Heat Operation - Mitsubishi Electric City Multi PKFY-P06NAMU-E Technical & Service Manual

8-4. HEAT OPERATION

TIME SUN MON TUE WED THU FRI SAT
TIMER
AFTER
ERROR CODE
°F°C
°F°C
ONLY1Hr.
TEMP.
MENU ON/OFF
BACK MONITOR/SET DAY
PAR-21MAA CLOCK
Control modes
1-1. Thermoregulating function (Function to prevent restarting for
1. Thermoregulating
function 3 minutes)
• Room temp.
• Room temp.
Controlled by the remote controller (4-speed)
2. Fan
Give priority to under-mentioned controlled mode
2-1. Hot adjuster mode
2-2. Preheating exclusion mode
2-3. Thermo OFF mode (When the compressor off by the
thermoregulating)
2-4. Defrosting mode
2-1. Hot adjuster mode
The fan controller becomes the hot adjuster mode for the
following conditions.
A: HOT adjuster mode start
B: 5 min have passed since the condition A or the indoor
C: 2 min have passed since the condition B
<How to operate>
1 Press POWER ON/OFF button.
2 Press the operation MODE button to display HEAT.
3 Press the TEMP. button to set the desired temperature.
Hr ON
AFTER OFF
NOTE: The set temperature changes 2°F when the
FUNCTION
FILTER
WEEKLY
SIMPLE
AUTO OFF
ON/OFF
FILTER
<Display in HEAT operation>
CHECK TEST
[DEFROST]
OPERATION
CLEAR
The [DEFROST] symbol is only displayed during the defrost operation.
[STANDBY]
The [STANDBY] symbol is only displayed from the time the heating operation
starts unit the heated air begins to blow.
Control details
desired temp. 30 °F ···Thermo ON
desired temp. ···Thermo OFF
When starting the HEAT operation
When starting the compressor by the thermoregulating
When releasing the HEAT defrosting operation
Hot adjuster mode 1
[Low]
[Extra Low]
A B
Condenser/Evaporator temp. turned to be 95 °F or more
(Terminating the hot adjuster mode)
pressed one time. Heating 63 to 83°F.
Set fan speed by the remote controller
C
27
or button is
Remarks
Fan speed change notch
Refer to the model function table
1 "STAND BY" will be displayed
during the hot adjuster mode.
To be continued on the next page