Blanco BOSE610PX Instruction Manual page 18

cooking time below this value. In order to set the actually desired end of cooking time in a 24
hours range:
- Turn the knob left/right, the hours flash.
- Modify the flashing hours value turning the knob left/right.
- Push the knob to switch back and forth between hours and minutes or wait a few seconds
until the minutes flash.
- Modify the flashing minutes value turning the knob left/right.
- Wait until the new End of Cooking time value stops flashing.
The display will flash End and its value alternatively for a few seconds then it will show the
time of day and the letter to indicate that a delayed cooking has been programmed. As soon
as the delay time expires, the oven starts and works for the programmed cooking time. The
symbol is displayed.
At the end of any timed activity the control shuts down the oven, the buzzer sounds a
warning sequence (two short beeps repeated every 3 seconds) to recall the user attention, for a
maximum time and makes the time related icons ( , ) flash on the display. Push the
knob to silent the buzzer and reset the warning message.
Turn the mode selector to ZERO (OFF) position before reusing the oven.
Oven functions
The control can manage many cooking functions, here below described, The temperature
range is between 50°C and 250°C for most functions. Preset temperatures are mainly 190°C for
convection modes, 210°C for thermal modes and 230°C for grilling functions.
Exceptions are Eco-Bake (preset=190°C), Pyrolyse (fixed 475°C), and low temperature modes
(Light, Defrost, Keep Warm).
Eco Bake
This function is defined in order to obtain a consistent energy saving. The cooling fan is initially off
and turns on only when the inner parts temperature gets high. Cooking might be a little bit slower
than the standard Bake, especially when the oven is heavily loaded.
Defrost
This function is used to defrost frozen food in a short time. It doesn't heat up the oven, only the
convection fan works. The temperature display shows DEF to indicate that this special mode is
active.
Pyrolyse – self
clean
Turn the mode knob in the proper position to start a cleaning cycle. The temperature display
shows the writing 475°.
The clean time can be set according to the same rules of the automatic functions, and therefore the
pyrolitic cycle can be delayed.
18