Digipad Operations - Sony DHC-FLX7D Operating Instructions Manual

digipad operations

The remote is equipped with an unique digipad multi controlling device. You can control various
operations with this digipad. When touching the digipad, do not use utensil whose end is sharpened.
When this unit does not respond to the digipad operations, press the digipad a little harder.
A
B
8 GB
DVD, TUNER, TAPE A/B functions
Basic operation
Tap once
Tap twice
* When you tap the digipad while playing a DVD/VIDEO CD/CD/Super Audio CD,
playback pauses. Tap again to resume playback.
Slide from the left to the right
Slide from the right to the left
Slide from lower side to upper side
Slide from upper side to lower side
** If you keep on moving, you can operate as pressing and holding these buttons.
Adjusting the equalizer curve in EQ EDIT operations (page 50)
The curve made by sliding the finger is reflected in the display.
Selecting parameters in DSP EDIT and other adjustments
(page 50)
Slide in the direction until you reach the value you want (refer to each of the
operations).
Adjusting the position of the digipad
When the digipad operation is not carried out properly or when you replace the
batteries, perform the following procedure. When carrying out this operation, make
sure to point the remote toward the main unit.
1
Turn on the system.
2 Press DISPLAY and . on the remote at the same time.
"CALIBRATION" flashes in the display.
3
Tap the dot at the left upper corner of the digipad.
"A PUSHED" appears in the display, then "CALIBRATION" flashes.
4
Tap the dot at the right bottom corner of the digipad.
"B PUSHED" appears in the display, then "CALIBRATION" flashes.
5
Press ENTER on the remote.
"CAL END" appears in the display.
DVD, TUNER, TAPE A/B
hH (Start playback)*
x (Stop playback)
> (AMS +, preset +)**
. (AMS –, preset –)**
M (Fast forward, tuning +)**
m (Rewind, tuning –)**