Speaker Setup - Sony DHC-FLX7D Operating Instructions Manual

x BALANCE
You can vary the balance of the left and right
speakers as follows. Be sure to set "TEST
TONE" to "ON" for easy adjustment.
• FRONT (CENTER): Adjust the balance
between the front left and right speakers (You
can adjust in 6 steps to left or right from center
position).
• REAR (CENTER): Adjust the balance
between the rear left and right speakers (You
can adjust in 6 steps to left or right from center
position).
x LEVEL
You can vary the level of each speakers as
follows. Be sure to set "TEST TONE" to "ON"
for easy adjustment.
• CENTER (0 dB): Adjust the level of the
center speaker (–6 dB to +6 dB, 1 dB steps).
• REAR (0 dB): Adjust the level of the rear
speakers (–6 dB to +6 dB, 1 dB steps).
• SUBWOOFER (+2 dB): Adjust the level of
the sub woofer (–6 dB to +6 dB, 1 dB steps).
x TEST TONE
The speakers will emit a test tone to adjust
"BALANCE" and "LEVEL".
• OFF: The test tone is not emitted from the
speakers.
• ON: The test tone is emitted from each
speaker in sequence while adjusting balance
or level. When you select one of the
"SPEAKER SETUP" items, the test tone is
emitted from both left and right speakers
simultaneously.
To adjust the volume of all the
speakers at once
Turn VOLUME (or press VOLUME +/– on the
remote).
30 GB
Adjusting the speaker volume
and level
Use the remote for the operation.
1
Press DVD SETUP while pressing
SHIFT in stop mode, then select

"SPEAKER SETUP".

2
Select "TEST TONE" and set "TEST
TONE" to "ON".
You will hear the test tone from each
speaker in sequence.
3
From your listening position, select
"BALANCE" or "LEVEL", then press B
or b repeatedly to adjust the value of
"BALANCE", or press V or v repeatedly
to adjust the value of "LEVEL".
The test tone is emitted from both left and
right speakers simultaneously.
4
Select "TEST TONE" and set "TEST
TONE" to "OFF" to turn off the test
tone.
Notes
• When you adjust the speaker settings, the sound cuts
off for a moment.
• If you adjust these parameters using OSD while
adjusting the speaker parameters using AMP MENU
(pages 13 and 14), the display on the unit turns off.