Specifying The Speaker Parameters - Sony DHC-FLX7D Operating Instructions Manual

x Rear speaker position and
height
Specify the position and height of the rear
speakers. The default settings are underlined.
Position diagram
• R. PL. BEHIND
Select this if the rear speakers are located in
the section B.
• R. PL. SIDE
Select this if the rear speakers are located in
the section A.
Height diagram
• R. HGT. LOW
Select this if the rear speakers are located in
the section D.
• R. HGT. HIGH
Select this if the rear speakers are located in
the section C.
14 GB
90
A A
45
B B
20
C C
60
D D
30
Specifying the speaker
parameters
Use the remote for the operation.
1
From your listening position, press
AMP MENU.
Adjustable menus and parameters are
described below.
2
Press V or v repeatedly until "LEVEL
MENU" appears.
3
Press ENTER.
4
Press V or v repeatedly to select the
parameter.
5
Press B or b repeatedly to select the
setting you want.
6
Repeat steps 4 to 5 to set other
parameters.
7
Press ENTER.
Tips
• You can use the digipad instead of the cursor buttons
(V/v/B/b).
• You can use "SPEAKER SETUP" in the Setup
Display to specify the balance, level, and test tone
parameters (page 29).
Adjustable parameters
The default settings are in the parentheses.
x BALANCE
• FRNT L___R: (center)
Balance between the front left and right
speakers.
• REAR L___R: (center)
Balance between the rear left and right
speakers.
Range: 6 steps to the left and 6 steps to the right
(13 steps)