Battery Installation - Polaris Ranger 800 HD Owner's Manual

Battery

Battery Installation

Using a new battery that has not been fully charged can damage the bat-
tery and result in a shorter life. It can also hinder vehicle performance.
Follow the battery charging instructions on page 96 before installing the
battery.
1. Ensure that the battery is fully
charged.
2. Place the fully charged battery in
the battery holder. Make sure the
positive terminal is toward the
driver's side of the vehicle.
3. With conventional batteries, install
the battery vent tube and route it
down in front of the shift cable,
into the left front wheel well.
4. Route the vent tube through the
hole in the frame support from the
back side and place it behind the
wheel well panel.
NOTICE: Route vent tube as shown to
prevent electrolyte from
damaging critical components
(such as wire harness, brake
lines, throttle cable).
WARNING! Battery gases could
accumulate in an improperly installed vent
tube and cause an explosion, resulting in
serious injury or death. Always ensure that
the vent tube is free of obstructions and is
securely installed as recommended.
5. On conventional batteries, coat the
terminals with dielectric grease or petroleum jelly.
6. Connect and tighten the red (+) cable first. Connect and tighten the
black (-) cable last.
7. Verify that cables are properly routed and install the hold-down
strap.
MAINTENANCE
Route through
hole in frame
Vent
Tube
Shift
Cable
Route
behind
panel
95