Starting The Engine; Stopping The Engine - Polaris Ranger 800 HD Owner's Manual

OPERATION

Starting the Engine

1. Always start the engine outdoors or in a well-ventilated area.
2. Sit in the driver's seat and fasten the seat belt. Secure the cab nets.
3. Apply the brakes. Engage the park brake.
4. Shift the transmission to neutral.
5. Do not press the throttle pedal while starting the engine. Turn the
ignition key past the ON/RUN position to START. Engage the
starter for a maximum of five seconds. Release the key when the
engine starts.
6. If the engine does not start within five seconds, release the ignition
switch and wait five seconds. Repeat steps 5 and 6 until the engine
starts.
7. Vary the engine RPM slightly with the throttle to aid in warm up
until the engine idles smoothly.
NOTICE: Operating the vehicle immediately after starting could cause engine
damage. Allow the engine to warm up for several minutes before
operating the vehicle.

Stopping the Engine

1. Release the throttle pedal completely and brake to a complete stop.
2. Turn the engine off.
3. Engage the park brake.
WARNING! A rolling vehicle can cause serious injury. Always engage the park
brake after stopping the engine.
Braking
1. Release the throttle pedal completely.
2. Press on the brake pedal evenly and firmly.
3. Practice starting and stopping (using the brakes) until you're famil-
iar with the controls.
Tip: When the throttle pedal is released completely and the engine speed drops
near an idle, the vehicle has no engine braking.
42