Assembly Instructions - Diamondback Response R8c Owner's Manual

Assembly Instructions

Response R8c
Assembly Hardware Kit
DP #22-10-1226
Flat Washers for seat base
ID 8.0 mm (4)
Allen Wrench
Hex Bolts for seat base
M8.0 x 1.25 x 45 mm (4)
Pedal Wrench / Screwdriver
(1)
Crank Bolt & Nut Wrench / Screwdriver
(1)
Notes:
Model: Response R8c Assembly Hardware Kit Card
Year: DB Fitness 2010
Graphics Prepared by: Skip Reys; sreys@diamondbackfitness.com
• Please read the entire R8c Owner's
Manual prior to beginning the assembly.
• Review the package contents to ensure
all listed parts are included.
• The assembly will require a 15 mm box
wrench, a 6 mm hex wrench, a 15 mm
pedal wrench, and a Phillips screwdriver.
All required tools are included.
• The estimated assembly time (of the
R8c) for a person familiar with basic
tool usage is thirty (30) to forty-five (45)
minutes.
Handlebar Clamp (1)
(1)
Hex Bolts for
handlebar clamp
M7 .0 x 1.0 x 30 mm (2)
Flat Washers
for handlebar
clamp
ID 7.0 mm (2)
Lock Washers
for handlebar
clamp
ID 7.0 mm (2)
Date Created:
30-Mar-10
Remove the hex fixing bolts (B) from the front stabilizer (A) and rear
stabilizer (C). Align the holes in the main frame with the recessed nuts in
the stabilizers and reinstall the fixing bolts.
Level the base by adjusting the leveling feet integrated into each of the
rear stabilizer end caps (D). Rotate the knobs counter-clockwise to raise
the feet and clockwise to lower them.
Remove the left and right crank caps (EE), un-threading them counter-
clockwise. Tighten both crank nuts (clockwise) with the enclosed box
wrench and replace the crank caps.
Thread the left pedal (E1) into the left crank in a counter-clockwise
direction. Tighten firmly with the pedal wrench.
Install the right pedal (E2) into the right crank, tightening in a clockwise
direction. Reinstall the crank caps (EE).
E
C
A
HH
EE
EE
E
1
2
C
D
B
1
7