Assembly Instructions - Diamondback 910Ub Owner's Manual

ASSEMBLY INSTRUCTIONS
8
1. Unpack the 910Ub from the carton. Please recycle.
2. Verify the carton contains all parts from the
list.
3. Remove the short section of steel tubing from the
front stabilizer receiver by removing the two (2) hex
fixing bolts with the enclosed wrench. Discard this
item.
4. Thread the four (4) stabilizer feet (F‐2) into the
underside of the front and rear stabilizers (F & G).
5. Align the front stabilizer assembly (F) with the
receiver mounted to the frame and loosely install
two (2) sets of the Allen bolt and curved washer
assemblies (I‐8 & I‐9) through frame and into the
front stabilizer (F).
6. Loosely install two (2) sets of the Allen bolt and flat
washer assemblies (I‐8 & I‐7) through the underside
of the frame receiver and into front stabilizer (F).
7. Align the rear stabilizer (G) with the frame and
loosely install two (2) sets of Allen bolt and curved
washer assemblies (I‐8 & I‐9) through frame and into
the rear stabilizer (G).
8. Loosely install two (2) sets of Allen bolt and flat
washer assemblies (I‐8 & I‐7) through underside of
the frame receiver and into rear stabilizer (G).
9. Tighten all eight (8) Allen bolts (I‐8) firmly with
provided Allen wrench to fix the front and rear
stabilizers.