Table of Contents
Advertisement
In the event of a fault with the hob, please advise CDA Customer Care
of any fault code shown on the display
Contact CDA Customer Care
A: Customer Care Department, The CDA Group Ltd, Harby Road,
Langar, Nottinghamshire, NG13 9HY
T: 01949 862 012
E: service@cda.eu W: www.cda.eu
Troubleshooting
On first use
You observe that
The display shows a series
of digits and symbols on first
connection
Installation blows a fuse or
only one side of the hob works
The hob produces an odour
during the first cooking sessions
On switching on
You observe that
The hob does not work and the
lights on the control panel do not
switch on.
The hob is not working and the
display shows a non-standard
graphic.
The hob is not working and all
the zone displays show "L".
9
F: 01949 862 003
Possible Causes
Working normally
The electrical connection of the
hob is incorrect
New appliance
Possible Causes
The hob is not connected to
the power supply or the power
supply is faulty.
The electronics are not
functioning correctly.
The key lock is on.
fast frying steaks
What should you do?
Nothing, the hob will be ready
to use within approximately 10
seconds
Check that it is set up properly
(see the Electrical Connection
section)
Heat a saucepan full of water
on each cooking zone for 30
minutes
What should you do?
Check the electrical circuit
breaker and fuses.
Call CDA Customer Care.
Switch off the key lock before
trying to use the hob.
17
Advertisement
Table of Contents
