This Zxd30P Accessory Is Designed To Fit 30" Warming Drawers Manufactured After February; Professional Style Panel; Accessory Kit Installation; Zkd910 - GE ZKD910 Installation Instructions Manual

Installation
Instructions
BEFORE YOU BEGIN
Read these instructions completely and carefully.
IMPORTANT
• –
for local inspector's use. Observe all governing
codes and ordinances.
• Note to Installer – Be sure to leave these
instructions with the Consumer.
• Note to Consumer – Keep these instructions
for future reference.
TOOL AND MATERIALS REQUIRED
• Phillips screwdriver
PARTS SUPPLIED
Stainless Steel Professional Style Drawer
Accessory
This kit contains a stainless steel professional style
panel with a handle and a lamp jewel imbedded in
the bottom right side. Install the warming drawer
according to the installation instructions packed
with the product.
NOTE: The ZXD30P professional drawer panel
with handle is a one-piece assembly that replaces
the original drawer front and tubular handle. The
original tubular handle (or a custom handle) cannot
be installed onto this professional drawer panel.
This ZXD30P accessory is designed to fit 30" warming
drawers manufactured after February 2006.
STEP 1
PREPARE DRAWER
FOR PANEL INSTALLATION
IMPORTANT: The drawer must be installed into
the cabinet before opening the drawer.
• Open the drawer approximately halfway.
• Turn the warming drawer to "OFF."
Save these instructions

PROFESSIONAL STYLE PANEL

ACCESSORY KIT
STEP 2
REMOVE ORIGINAL
DRAWER FRONT
• Remove the three screws from the bottom
of the drawer edge.
• Remove the four screws on the inside
of the drawer at the top. Retain all screws.
– Support the drawer front as you remove screws
to prevent the front panel from falling
REMO VE THE PACKAGING
STEP 3
• Open the carton and remove the panel.
Remove all protective covering on both sides.
CAUTION:
away from babies and small children. Plastic could
pose a choking or suffocation hazard.
STEP 4
INSTALL PANEL ONTO DRAWER
• Install the panel assembly to the exposed drawer
front using the original 7 screws.
12

ZXD30P

.
Keep all plastic material