Provide Cabinet Support; Step 1, Anti-Tip Brackets; Step 2 Install Warming Drawer; Zkd910 - GE Monogram ZKD910 Installation Instructions Manual

installation
PROVIDE CABINET SUPPORT
23-1/2"
2"x4"or
EquivalentRunners
,
_ ,
i i
i i
i i
i
i i
i i
i i
i i
i i
i i
i i
i i
i i
i
i i
i i i
_22"_
27"
IMPORTANT:When installedbelowa singleor doubleoven,checkto besure
thatany ovensupports abovethe cutoutdo not obstruct t he 23-1/2"required depth
of the warming drawercutout.
. A 2" min. clearance between oven and warming drawer
cutouts are required. Additional clearance mag be
required if 2 x a blocks are used to support runners
or solid floor of the oven above.
. The warmer drawer mag be supported by either
a solid bottom, 2 x a or 2 x 2 runners.
23-1/2"
2"x4" or
Equivalent R unners
/ \
/
i
/ i
i i
i i
i i
i i
i i
i i
4_25"_
30"
i m
. The support must be level and rigidlg mounted,
flush with the bottom edge of the cutout.
- There is no wag to level the drawer once it
has been installed. Be sure supports are level.
° The entire weight of the drawer is supported bg
the runners or solid floor and must be capable
of supporting 150 Ibs.
i STEP i i INSTALL ANTI-TIP BRACKETS
WARNING
ANTI-TIP PRECAUTIONS
An anti-tip brace must be installed to prevent
the drawer from tipping forward when opened
end loaded. Failure to do so could result in
personal injurg.
.............. t °° I_
._
2x4or 2x2
Runners or Solid
Bottom
Install 2x4or 2x2
.... -- Anti-TipBlock
Against Rear
CabinetWall 9"
FromFloorto
Bottomof Block
STEP 2 INSTALL WARMING DRAWER
° Slide the left corner of the drawer into the opening.
° Push the power cord into the hole leading to the outlet
location. Thread the cord through as the drawer is being
pushed back into the opening. Check to be sure the
power cord does not get trapped under the drawer.
- If the outlet is installed inside the opening, plug the cord
into the outlet. In this location, the excess power cord
length should be coiled and taped to the right side
of the unit.
. Push the drawer back until the front flange is flush
to the cabinet front.
. Open the drawer fullg.
° Drill pilot holes through the holes in the overlapping
frame, one on each corner.
° Drive the wood screws provided into each corner.
9