Table of Contents
Advertisement
Installation
PROVIDE CABINET SUPPORT
2'x4" of
Equivalent Runners
23-1/2"
+
29" ——+
2]"
IMPORTANT: When installed below a single or double oven, check to be sure
that any oven supports above the cutout do not obstruct the 23-1/2" required depth
of the warming drawer cutout.
eA 2" min. clearance between oven and warming drawer
cutouts are required. Additional clearance may be
required if 2 x 4 blocks are used to support runners
or solid floor of the oven above.
e The warmer drawer may be supported by either
asolid bottom, 2x4 or 2x 2 runners.
2'x4" of
Equivalent Runners
23-1/2"
=
1 Ld
|
——
I
e The support must be level and rigidly mounted,
flush with the bottom edge of the cutout.
~ There is no way to level the drawer once it
has been installed. Be sure supports are level.
e The entire weight of the drawer is supported by
the runners or solid floor and must be capable
of supporting 150 Ibs.
STEP 1 | INSTALL ANTI-TIP BRACKETS
AWARNING
ANTI-TIP PRECAUTIONS
An anti-tip brace must be installed to prevent
the drawer from tipping forward when opened
and loaded. Failure to do so could result in
personal injury.
Install 2x4 or 2x2
|_-—- Anti-fip Block
r m
Against Rear
4
Cabinet Wall 9"
g"
From Floor to
|
Bottom of Block
a
2x4 or 2x2
Runners or Solid
:
Bottom
STEP 2 | INSTALL WARMING DRAWER
# Slide the left corner of the drawer into the opening.
«Push the power cord into the hole leading to the outlet
location. Thread the cord through as the drawer is being
pushed back into the opening. Check to be sure the
power cord does not get trapped under the drawer.
- If the outlet is installed inside the opening, plug the cord
into the outlet. In this location, the excess power cord
length should be coiled and taped to the right side
of the unit.
e Push the drawer back until the front flange is flush
to the cabinet front.
«Open the drawer fully.
¢ Drill pilot holes through the holes in the overlapping
frame, one on each corner.
e Drive the wood screws provided into each corner.
Advertisement
Table of Contents
