STEP 4
SECURE CUSTOM PANEL
TO METAL MOUNTING PANEL
• Lay the custom panel, appearance side down,
on a clean surface.
• Place the flat side of the metal panel onto the back
side of the custom panel, with the mounting flanges
facing up.
• Align the lamp hole in the panel with the mounting
panel.
• Check top, bottom and side overlap dimensions
from the metal panel to wood panel edge as shown.
1/4"
Top
Handle
Attachment Holes
Bottom
Align Holes
Back side of Appearance Panel with Support Panel
STEP 5
FOR PANELS LESS
THAN 3/4" THICK
• Separate the custom panel and metal panel.
• Apply a few horizontal beads of adhesive
to the metal panel. Avoid adhesive within 1"
of lamp hole area and outer edges.
STEP 5A
FOR 3/4" (OR GREATER)
THICK PANELS
3/4" thick panels may be secured to the metal panel
with screws.
• Use the metal panel as a template. Position the metal
panel over the back side of the custom panel and drill
pilot holes. Drill pilot holes sized to match screws being
used (screws not provided).
CAUTION:
to avoid penetration of the finished side.
Installation
7/32"
Select screw length carefully
STEP 6
Turn the assembly appearance side up.
• Use plastic to wood adhesive to secure the lamp
jewel to the front of the wood panel. On the side
with the bulge, (see illustration) apply a small
bead of adhesive around the outside edge.
Place the jewel into the drilled hole.
This Side
Against
Wood
3/16"
STEP 7
1/4"
A custom handle (not supplied) may be installed.
• Drill pilot holes through the front of the custom
panel and through the metal panel to match
the chosen handle.
NOTE: The handle screws should be installed through
the metal panel, the custom panel and into the custom
or original handle.
STEP 8
• Install the custom panel assembly to the exposed
drawer front using the original 7 screws.
11
INSTALL LAMP JEWEL
Appearance
Side
REINSTALL ORIGINAL
HANDLE OR OPTIONAL
CUSTOM HANDLE
INSTALL ASSEMBLED PANEL
TO THE DRAWER
Custom Handle
or Original Handle
Insert
Jewel