Table of Contents
Advertisement
IMPORTANT:
When correctly installed, your product meets all safety
requirements laid down for this type of product. However, special
care should be taken around the rear or the underneath of the
appliance as these areas are not designed or intended to be
touched and may contain sharp or rough edges that could cause
injury.
Fitting the Hob
Unpacking the hob:
Take care not to lose or mishandle any parts.
Fitting position of the hob:
This appliance must be installed a minimum of 50mm from any
back wall and a minimum of 180mm away from any adjacent vertical
surfaces, e.g. a tall cupboard end panel. This may be reduced to
100mm if the adjacent surface is resistant to fire (tiles or steel, for
example). These dimensions are shown in Fig. 5.
Ventilation requirements:
This appliance must be installed to allow air to flow freely to the air
intake, from the air outlet and in the base and run of units into which
it is installed (Fig 3). Failure to allow sufficient ventilation could cause
damage to the hob and constitutes incorrect installation, which is not
covered by the warranty.
Notes:
•
This could be a simple slot cut out of the plinth, or a dedicated
19
Advertisement
Table of Contents
