Wds (Wireless Distribution System) - Digisol DG-BR4015N User Manual

Here are the descriptions of every setup item.
Parameter Description
WPS mode Select Enable from drop down list to start WPS function.
PBC Select PBC if you wish to connect using push button. Also, enable
PBC on clients so they can connect with WPS security.
PIN Enter the PIN obtained from client into the router so as to connect
using WPS security.
You can view the WPS current status under summary.

2-6-5 WDS (Wireless Distribution System)

WDS mode is used to extend the wireless network coverage. The AP/Router can be
linked to other AP using WDS. To set up links between access point units, you must
configure the Wireless Distribution System (WDS) forwarding table by specifying the
wireless MAC address of all units to which you want to forward traffic.
This uses the MAC addresses of the station and that of the AP connected to it on the
transmitting LAN, and the MAC addresses of the AP functioning as a wireless
repeater/bridge and that of the station connected to it on a neighboring LAN in the 802.11
frame header.
Note: The wireless AP/Router does not support the spanning tree algorithm. WDS
links should be configured appropriately to avoid causing loops on the network.
To set WDS settings, Please click 'WDS' menu on the left of web management interface,
under the 'Wireless' tab.
Here are the descriptions of every setup item.
DG-BR4015N User Manual
58