Headlight Aim Inspection - Victory Cross Roads Owner's Manual

Maintenance
Seat Removal / Installation
1. Remove the side covers. See page 80.
2. Remove the two seat screws.
Tool: 6 mm Allen wrench
3. Lift the front of the seat upward and pull
forward to disengage the tab at the rear of
the seat. If equipped, unplug the seat
heater.
4. To install, reverse the above process, being
sure to engage the tab at the back of the
seat.
5. Tighten the seat screws.
Torque: 10 ft-lbs (13.5 Nm)

Headlight Aim Inspection

The top edge of the high beam must be 3 inches (7.6 cm) below the widest part of the head-
light and centered straight ahead at 25 feet (7.6 m).
CROSS ROADS (High Beam)
25 ft. (7.6 m)
3 in. (7.6 cm)
Height of widest part
of headlight
1. Verify that tire pressure is at specification. See page 76.
2. Verify that rear suspension ride height (preload) is at specification. See page 66.
3. Position the motorcycle on a level surface with the headlight 25 feet (7.6 m) from a wall.
4. With the operator and passenger (if applicable) on board, bring the motorcycle to the
fully upright position.
5. Move the ignition switch to the ON position and switch the headlamp to high beam.
Observe the headlight aim on the wall.
6. Make any necessary adjustments to headlight aim. See page 83.
82
Seat Screws
10 ft-lbs (13.5 Nm)
CROSS COUNTRY (High Beam)
25 ft. (7.6 m)
3 in. (7.6 cm)
Height of widest part
of headlight