Pedal Adjustment - Victory Cross Roads Owner's Manual

Brakes
The front brake lever activates the front brake calipers. The rear brake pedal activates the
rear brake caliper. For maximum brake effectiveness, apply the front brake lever and the rear
brake pedal together.
Front Brake Lever
The front brake lever is located on the right handlebar.
This lever controls only the front brakes. The front
brakes should be applied simultaneously with the rear
brakes. To apply the front brake, pull the lever toward
the handlebar. See page 49 for braking procedures.
Front brake lever reach (distance to the hand grip) is
adjustable.
1. Pull and hold the lever away from the hand grip.
2. To increase reach distance, rotate the adjuster to align a lower number with the arrow on
the lever.
3. To decrease reach distance, rotate the adjuster to align a higher number with the arrow on
the lever.
Rear Brake Pedal
The rear brake pedal is located on the right side
of the motorcycle. Press downward on the rear
brake pedal to apply the rear brake.
See page 33 for pedal adjustment options. See
page 49 for braking procedures.

Pedal Adjustment

The brake pedal and gear shift pedal controls can be
adjusted to a front, rear or center position. The center posi-
tion is the factory setting.
1. Remove the screw from the footwell support.
Tool: 6 mm Allen wrench
2. Slide the control forward or rearward in its track until
the threaded hole of the control aligns with the desired
hole in the footrest support.
3. Reinstall the screw.
Torque: 96 in-lbs (11 Nm)
4. After adjusting the shift pedal, always readjust the
shift linkage rod. Loosen both jam nuts on the linkage
and turn the shaft until the footpeg is about 90 mm
from the floorboard (or to desired height). Tighten
both jam nuts.
Torque: 96 in-lbs (11 Nm)
Instruments, Features and Controls
Front Brake
Lever
Center Adjustment
Position
33