Table of Contents
Advertisement
P
562 U
'
M
I
UMP
SER
S
ANUAL
Front Panel Controls and Indicators
The iPump562 can be controlled via
primary method of controlling the iPump562.
LCD
Arrow buttons
ENTER
LED
LED Indications
The iPump562 supplies an operational status using the LED. A steady
alarm conditions. The LED will flash when receiving commands from Compel or when downloading files.
If there is a problem, the LED flashes
that the unit cannot produce output, while Warnings indicate that, although output is being produced, there is a problem that
could require attention.
Mode
Alarm
4
Compel network control
lef
t arrow button
top arrow button
bottom arrow button
LCD screen
iPump 562
Item
Displays unit label and current status unless OSD activated, in which case
it displays the active OSD line.
Arrow buttons activate OSD and navigate through the menus.
Selects next menu level or item selected on OSD.
Indicates status: green for OK, flashing red for alarm, flashing amber for
warning.
Red
for alarm conditions or
Front Panel Status LED Alarm and Warning Indications
iPump 562
LED Status
Red blink = 2
Red blink = 4
Red blink = 5
Red blink = 11
800092-02 Rev. C
, local terminal, and
Front Panel
iPump 562
right arrow button
Enter button
Front Panel Controls
Description
Green
Amber
for warning conditions. In general, alarms indicate
No carrier
In recovery
Eb/No alarm
Not authorized
. Normally,
On-Screen-Display
LED
LED indicates that there are no warning or
Condition
www.wegener.com
is the
Compel
Advertisement
Table of Contents
