Table of Contents
Advertisement
P
562 U
'
M
I
UMP
SER
S
ANUAL
Compel Method
CAUTION: Changing the method of Compel control should be done with care as it could result in a loss of control if
not set correctly. It is recommended to issue the specific method setup commands mentioned below before issuing
the "compel method" command.
The unit may be controlled via the Compel control system using one of three connection methods, dvbpid, mcast, or http. The
method is set by issuing one of the following commands:
"compel method dvbpid" - This is the default control method. Compel will control the unit by sending commands in the
MPEG transport stream on the the tuned RF carrier. With this method, the PID of the Compel commands must be set in the
unit by issuing the command: "compel pid 1026". The PID number (1026) is expressed in hexadecimal. This setting must
match the setting in the Compel control system.
"compel method mcast" - Compel will control the unit by sending commands in a multicast IP transmission. The multicast
IP address and port must be set by issuing the following command: "compel mcsetup [address] [port]", where [address] is the
multicast IP address and [port] is the multicast port number. When using this method, Compel will also deliver assets over a
multicast IP transmission and the multicast address and port for asset delivery must also be set by issuing the following
command: "afd mcsetup [address] [port]" , where [address] is the multicast IP address and [port] is the multicast port number.
"compel method http" - Compel will hold all commands in a database until retrieved by the unit over IP. With this method,
a server IP address must be set in the unit that matches the Compel IP address. This is done with the command: cmplint
srvraddr [address] , where [address] is the Compel IP address. Assets will also be retrieved via this server address.
26
800092-02 Rev. C
www.wegener.com
Advertisement
Table of Contents
