Table of Contents
Advertisement
A. E
F
V
LECTRIC
UEL
The electric fuel valves are wired to the ignition
switch. When the ignition is turned ON the valve
opens, when the ignition is turned OFF the valve
closes. The manual override knob on the side of
the valve should be left in the OFF position at all
times.
In the event of an electrical malfunction, the valve
can be opened and closed manually by turning the
manual override knob.
The electric fuel valve is installed in-line on the fuel
hose between the fuel tank the engines and
generator.
E
F
V
(
LECTRIC
UEL
ALVE
MANUAL OVERRIDE
ON/OFF KNOB
POSITION FOR
NORMAL OPERATION
B. D
F
S
IESEL
UEL
YSTEM
O
)
PTION
The diesel fuel system consists of two fuel tanks
with a total capacity of 225 gallon (851 liters), fuel
tank vent, shut-off valve, engine fuel supply and
return line, fuel filters and fuel fills (Figure 5.2.1).
®
340 Sundancer
(375 Sundancer
S
5 • F
ECTION
(G
)
ALVES
ASOLINE
. 5.3.1)
FIG
KEEP IN OFF
(
D
E
WITH
IESEL
NGINE
®
)
S
UEL
YSTEM
C. F
F
(D
UEL
ILTER
IESEL
Primary and secondary fuel filters are located on your
Sea Ray
®
to help keep the fuel as clean as possible.
Primary fuel filters are the Racor
fuel filters installed in the engine compartment
(Figure 5.3.1). The secondary fuel filters are located
on the engine and should be replaced in accordance
with the Engine Owner's Manual.
NOTE: Use of any methanol, gasohol or alcohol
based fuel additive will damage the fuel filter.
REFER TO THE ENGINE OPERATOR'S MANUAL
FOR MORE DETAILED INFORMATION.
2. F
F
M
UEL
ILTER
A major cause of poor starting or power loss is the
result of a clogged filter element or a fuel system
air leak. Check that the filter lid and drain plug are
properly tightened.
Inspect or drain the collection bowl of water daily.
A. T
D
W
O
RAIN
ATER
1.
Shut down the engine.
2.
Loosen the T-handle on the top lid to break the
vacuum within the filter (see Fig. 5.4.1).
3.
With a suitable collection container in place,
remove the drain plug and allow water and
contaminants to drain. (see Fig. 5.4.2).
4.
Replace the drain plug and, if necessary, prime
the filter by removing the lid (see Fig. 5.4.3)
and filling the filter with clean fuel.
5.
Replace the lid and tighten the lid T-handle by
hand only. Do not overtighten.
Replace the filter element at regular intervals or if a
power loss is detected.
)
®
water separating
(D
AINTENANCE
IESEL
:
)
5.3
Advertisement
Table of Contents
