Table of Contents
Advertisement
S
ECTION
C. D
P
RAIN
LUG
!
DANGER
Install and tighten drain plug before launching boat.
Boat will sink if drain plug is not in place and tight.
The bottom of the engine compartment is called the
"bilge". It is the lowest and inner part of the hull.
Water and other liquids will collect here.
After removing your boat from the water, unthread
the drain plug to drain the bilge (Figure 4.2.1).
D
P
RAIN
LUG
(F
. 4.2.1)
IG
TRANSOM HULL
URETHANE
CAULK
D. B
P
ILGE
UMPS
!
WARNING
SINKING HAZARD – Ensure the bilge pumps are
operating properly.
!
Run bilge pumps in the manual position only as
long as necessary to remove water. Running bilge
pumps dry can damage the pump motor.
A bilge pump and float switch are located in the
bottom of the bilge (Figure 4.2.3). The bilge pump
is manually activated from the switch panel located
on the helm (Figure 4.2.2).
4.2
4 • B
ILGE
GARBOARD
DRAIN
DRAIN PLUG
CAUTION
& U
NDERWATER
Before starting the engine, press the bilge pump
switch so that the switch light comes ON. Make sure
the pump is working by opening the engine
compartment, listening to hear the pump running
and check to see that liquid is being pumped out
from the hull discharge (See Fig. 2.10.1). If the bilge
has more liquid than normal, see Maintenance
Section for locating and correcting the problem.
Except for checking the operation of the bilge pump
using the ON position, leave the switch in the OFF
(AUTO) position. In the OFF (AUTO) position, when
the bilge liquid is deep enough to activate the float
switch, the bilge pump turns on and pumps out the
bilge liquid until the float switch drops and shuts off
yyy
the pump.
B
P
B
ILGE
UMP AND
(L
S
P
EFT
WITCH
ANEL
yyy
BILGE BLOWER
yyy
BILGE PUMP
B
P
& F
ILGE
UMP
LOAT
(F
. 4.2.3)
IG
BILGE PUMP
G
EAR
B
S
ILGE
LOWER
WITCH
) (F
. 4.2.2)
IG
S
WITCH
LOCK TAB
FLOAT SWITCH
KNOB TO MANUALLY TEST
FLOAT SWITCH AND PUMP
®
(375 Sundancer
340 Sundancer
®
)
Advertisement
Table of Contents
