Advanced Options - Lindy SC5 User Manual

Advanced Options

Advanced options are available only to the
Admin user and consist of settings that are
related to specialist areas such as DDC and
USB country code.
To get here
1 From a local or remote keyboard, log on
as a standard (limited options) or 'admin'
user.
2 Press (hotkeys can change).
3 Press to select 'More menus'.
4 Press again to select 'Advanced
menus'.
5 Select 'Setup Options'.
DDC Options
The options within this section are related to the Display Data Channel features
supported by the SC5. DDC is an industry standard format that allows computer
systems to be informed of the capabilities of the video monitor connected to
them.
DDC Source
Settings: AUTO, LOCAL, REMOTE, DEFAULT
Determines which user port monitor should be interrogated to discover its
capabilities. AUTO begins with the local user port and if it fails, it then checks
the remote port and if that also fails to produce a result, it uses a set of default
values. The LOCAL and REMOTE settings force the unit to interrogate only
the local and remote monitors respectively, and DEFAULT uses only the pre-
programmed settings.
DDC Refresh
Settings: AT START, DISABLED
AT START sets the SC5 to read DDC information from the selected source
at power up. When DISABLED, no new DDC data is sought and existing
information is used. When viewing this menu, press F7 to discover DDC
information from the chosen source immediately.
LINDY SC5
Advanced Options
DDC Options
USB Country Code
F1-More menus
Enter-Select
Esc-Quit
Firmware Version 1.01b06
continued