Adjusting The Direction Of Air Circulation - Fujitsu ASBA24LFC Operating Manual

ADJUSTING THE DIRECTION OF AIR CIRCULATION

● Adjust the up, down, left, and right AIR directions with the AIR DIRECTION buttons on the Remote Controller.
● Use the AIR DIRECTION buttons after the Indoor Unit has started operating and the airfl ow-direction louvers have stopped mov-
ing.
Vertical Air Direction Adjustment
Press the SET button (Vertical) (Fig. 6 S).
Each time the button is pressed, the air direction range will change as follows:
1
Types of Air fl ow Direction Setting:
1,2,3 : During Cooling/Dry modes
4,5,6 : During Heating mode
The Remote Controller's display does
not change.
● Use the air direction adjustments within the ranges shown above.
● The vertical airfl ow direction is set automatically as shown, in accordance with the type
of operation selected.
During Cooling/Dry mode
During Heating mode
● During AUTO mode operation, for the fi rst minute after beginning operation, airfl ow will
be horizontal 1; the air direction cannot be adjusted during this period.
● Direction 1
2
Only the direction of the Air Flow Direction Louver changes; the direction of the Power
Diffuser does not change.
Horizontal Air Direction Adjustment
Press the SET button (Horizontal)(Fig. 6 T).
● Each time the button is pressed, the air direction range will change as follows:
1
The remote controller's display
does not change.
2 3 4 5
: Horizontal fl ow 1
: Downward fl ow 5
2 3 4 5
1
2
3
4
6
1
2
3
4
5
6
5
DANGER!
● Never place fi ngers or foreign objects inside
the outlet ports, since the internal fan oper-
ates at high speed and could cause personal
injury.
● Always use the Remote Controller's
SET button to adjust the vertical airfl ow
louvers. Attempting to move them manu-
ally could result in improper operation; in
this case, stop operation and restart. The
louvers should begin to operate properly
again.
● During use of the Cooling and Dry modes,
do not set the Air Flow Direction Louvers
in the Heating range (4 -
periods of time, since water vapor may
condense near the outlet louvers and
drops of water may drip from the air
conditioner. During the Cooling and Dry
modes, if the Air Flow Direction Louvers
are left in the heating range for more than
30 minutes, they will automatically return
to position 3.
● When used in a room with infants,
children, elderly or sick persons, the air
direction and room temperature should
be considered carefully when making
settings.
6 ) for long
En-10