Adjusting The Direction Of Air Circulation - Fujitsu GENERAL ASH12RMACW Operating Manual

ADJUSTING THE DIRECTION OF AIR CIRCULATION

Instructions relating to heating (*) are applicable only to "HEAT & COOL MODEL" (Reverse Cycle).
Vertical (up-down) direction of airflow is adjusted by pressing the Remote Control Unit's AIR FLOW DIRECTION button. Hori-
zontal (right-left) airflow direction is adjusted manually, by moving the Air Flow Direction Louvers.
Whenever making horizontal airflow adjustments, start air conditioner operation and be sure that the vertical air direction
louvers are stopped.
Vertical Air Direction Adjustment
Press the AIR FLOW DIRECTION button (Fig. 6 O).
Each time the button is pressed, the air direction range will change as follows:
1
Types of Air flow Direction Setting:
1,2,3,4
: During Cooling/Dry modes
5,6,7 : * During Heating mode
The remote control unit's display does
not change.
G Use the air direction adjustments within the ranges shown above.
G The vertical airflow direction is set automatically as shown, in accordance with
the type of operation selected.
During Cooling/Dry modes : Horizontal flow 1
* During Heating mode
G During AUTO mode operation, for the first minute after beginning operation,
airflow will be horizontal 1; the air direction cannot be adjusted during this pe-
riod.
Right-Left Adjustment
Adjust the Right-Left louvers.
G Move the Right-Left louvers to adjust air flow in the direction you prefer.
En-11
2 3 4 5
: Downward flow 7
Right-Left Louvers
knob
6 7
DANGER!
Never place fingers or foreign objects inside
the outlet ports, since the internal fan oper-
ates at high speed and could cause personal
injury.
G Always use the remote control unit's
AIR FLOW DIRECTION button to adjust
the vertical airflow louvers. Attempting
to move them manually could result in
improper operation; in this case, stop
operation and restart. The louvers
should begin to operate properly again.
G During use of the Cooling and Dry
modes, do not set the Air Flow Direc-
tion Louvers in the range (5 to 7) for
long periods of time, since water vapor
may condense near the outlet louvers
and drops of water may drip from the
air conditioner. During the Cooling and
Dry modes, if the Air Flow Direction
Louvers are left in the range (5 to 7)
for more than 30 minutes, they will au-
tomatically return to position 4.
G When used in a room with infants, chil-
dren, elderly or sick persons, the air
direction and room temperature
should be considered carefully when
making settings.