Before First Use - CDA WC461 Manual For Installation, Use And Maintenance

Important
• Read the instructions prior to installation and use of the appliance.
• Do not lean or climb on the open dishwasher door to prevent damage.
• Close the dishwasher door after use to prevent accidents.
• Use only detergents, salt and rinse aid specifically designed for dishwashers.
• Do not put solvents in the dishwasher detergent compartment to prevent risk of explosion
• Only put dishwasher safe items into the dishwasher. If in doubt, check with the manufacturer of the items.
• Take care when loading the dishwasher to observe the recommendations for best loading practice, and also to ensure
that sharp objects such as knives are placed blade down to prevent accidents.
• Do not open the dishwasher door when a programme is running. If it is necessary to do so, then open it
only slightly to allow the dishwasher to pause the programme and prevent any water spilling out. Remember that the
water in the dishwasher can be very hot when the programme is running.
• When the dishwasher is not in use, we reccomend that you turn off the water supply at the supply tap and disconnect
the main supply.
• If you are leaving the dishwasher for an extended period you should leave the door slightly open to prevent the
formation of unpleasant smells.
• The plastic housing on the water inlet pipe contains an electrically operated valve. The wires that connect to this
valve are inside the inlet hose. Do not cut through the inlet hose, and do not put the plastic housing in water.
• Children could get locked inside the appliance. Therefore when disposing of an old appliance, cut off the plug and
set aside, and damage the door lock so that the door can no longer be closed.
Recommendations
• To reduce energy and water consumption, remove all dirt residues from the dishes prior to loading the dishwasher.
• Only run the dishwasher when fully loaded.
• Place hollow items (bowls, glasses and pans) face down in the basket.
• Do not put dishes or cutlery with tobacco ash, wax, lubricating grease or paint residues in the dishwasher.

Before First Use

• Set the water softener level as required by the water hardness in the area.
• Add 1kg of salt into the salt compartment and then fill with water to the top of the salt compartment.
• Remove all the packaging materials from the interior of the dishwasher.
• Fill the rinse aid compartment.
• Run a hot programme without any dishes in the dishwasher.
3