Table of Contents
Advertisement
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for CDA WC370
Summary of Contents for CDA WC370
- Page 1 Manual for Installation, Use and Maintenance Passionate about style Customer Care Department • The Group Ltd. • Harby Road • Langar • Nottinghamshire • NG13 9HY T : 01949 862 012 F : 01949 862 003 E : service@cda.eu W : www.cda.eu...
- Page 2 Appliance information: Please enter the details on the appliance rating plate below for reference, to assist CDA Customer Care in the event of a ter the details on the appliance rating plate below for reference, to assist CDA Customer Care in the event of a fault with your appliance and to register your appliance for guarantee purposes.
-
Page 3: Before First Use
• The plastic housing on the water inlet pipe contains an electrically operated valve. The wires that connect to this valve are inside the inlet hose. Do not cut through the inlet hose, and do not put the plastic housing in water. •... -
Page 4: Control Panel
Control Panel Power button (1) • To switch the dishwasher on or off, press the power button (1). When you switch on the dishwasher, the end of programme light will illuminate, and two dashes will appear on the display. Programme display (2) The programme display shows the selected programme and the remaining time to run. - Page 5 Please note: You should ensure that there are no dishes in the upper basket when running a lower basket half-load programme, and none in the lower basket when running an upper basket half-load programme. If you have selected any extra function (3 in 1, prewash, half-load) for a programme, this function will automatically be selected the next time the dishwasher is used.
- Page 6 “a” (figure 1). 3. Then close the detergent compartment lid until the latch locks. CDA recommends the use of separate detergent, rinse aid and dishwasher salt rather than combination tablets as separates achieve better wash performance.
- Page 7 If your dishes are in need of an intensive wash, then add 5 cm detergent into the prewash section of the compartment “a” (figure 2). CDA recommends the use of separate detergent, rinse aid and dishwasher salt rather than combination tablets as separates achieve better wash performance.
-
Page 8: Testing Strip
ENGLISH Testing strip The washing effectiveness of your machine depends on the softness of the tap water. For this reason, your machine is equipped with a system that reduces the hardness in mains water supply. The washing effectiveness will increase when the system is correctly set. To find out the water hardness level of water in your area, contact your local water board or determine water hardness level by using the test strip(if available). -
Page 9: Rinse Aid
nse Aid Rinse Aid Rinse Aid Rinse Aid fill the rinse aid compartment To fill the rinse aid compartment To fill the rinse aid compartment Open the rinse aid compartment by turning and removing the cap as To fill the rinse aid compartment 1. -
Page 10: Dishwasher Baskets
Top basket height adjustment while i Dishwasher Baskets Dishwasher Baskets The upper basket has two different heights available, to allow for larger Baske To adjust the height of the upper basket: your m products in either the upper or lower basket. To raise or lower the upper Top basket height adjustment while it is full 1. - Page 11 Standard loading and Test Data Standard Loading and Test Data Capacity Capacity • Upper and lower baskets: 12 place settings. • Upper and lower baskets: 12 place settings. • The upper basket should be adjusted to high position. • The upper basket should be adjusted to high position. •...
-
Page 12: Programme Listing
Programme Listing Auto Auto- Auto- Programme name Intensive Express Economy Quick Prewash Intensive+ Intensive normal delicate and temperature 60-70 50-60 30-50 Level of soil High High High Medium Medium High Detergent required The dishwasher is equipped with a sensor that Prewash Prewash Prewash... -
Page 13: Care And Maintenance
Unplug your machine and turn off its ta gramme that runs at high temperature, and start the machine. In case of insufficiency, use ime may accumulate in the machine's washing section. In case of such Do not use hard materials when cleani ecial cleansing material available in the market. -
Page 14: Failure Codes And Troubleshooting
Close the water tap, separate the water inlet hose from the tap and Inadequate water supply. clean the filter. Restart your machine, contact CDA service if the error resumes. Faulty heater sensor. Contact CDA service. Overheating error (temperature in the Contact CDA service. - Page 15 Failure Codes and Troubleshooting Problem Possible cause Check the plug, fuse and circuit breakers of the mains supply. The water tap is turned off. The programme will not start The dishwasher door is not fully closed. The water inlet filter or the machine filters are blocked. The water drain hose is blocked or kinked.
-
Page 16: Electrical Information
Electrical information Warning! This appliance must be earthed. The mains lead of this appliance has been fitted with a BS 1363A 13 amp fused plug. To change a fuse in this type of plug, follow the steps below: 1. Remove the fuse cover and fuse. 2. -
Page 17: Installation
Installation Installation • Do not install this appliance if it is damaged in any way. Installing a • Do not install this appliance if it is damaged in any way. Installing a damaged appliance may invalidate the warranty. damaged appliance may invalidate the warranty. •... -
Page 18: Fitting The Integrated Appliance Door
Fitting the integrated appliance door Where non-standard integrated appliance doors are supplied, additional fitting instructions are required to ensure compatibility with this product. The machine is supplied with a fitting template and these instructions should be followed as normal. However, the fitting template needs to be located lower down the fascia door; this is shown below. - Page 19 Notes...
- Page 20 Passionate about style Customer Care Department • The Group Ltd. • Harby Road • Langar • Nottinghamshire • NG13 9HY T : 01949 862 012 F : 01949 862 003 E : service@cda.eu W : www.cda.eu...
Need help?
Do you have a question about the WC370 and is the answer not in the manual?
Questions and answers