Log Set Placement; Thermostat Installation - Quadra-Fire Santa Fe Pellet Stove Owner's Manual Installation And Operatio

R
E. Optional Log Set Placement Instructions
CAUTION
Logs are FRAGILE. Use extreme care when handling or
cleaning logs.
NOTE:
Due to the abrasive nature of a pellet appliance fi re, the
logs are not covered under warranty. Any placement varia-
tion other than shown here can cause excessive heat and
shall void the appliance warranty.
Two Piece Log Set Installation
1. Open door to expose the fi rebox.
2. Install the left log fi rst and then the right log. Figure 22.1
3. Lean the logs against the cast iron brick in the back of
the fi rebox.
4. Push the logs to the far left and far right against the
sides of the fi rebox. Figure 22.2.
5. To clean the logs, use a vaccum and a soft brush attach-
ment or a paint brush.
Figure 22.1
Figure 22.2
Page 22
F. Thermostat Installation
1 A 12 volt AC thermostat is required to operate this pellet
.
appliance. You may use the included wall mount thermo-
stat or purchase an optional programmable thermostat
or remote control. It is equipped with an adjustable heat
anticipator. The current rating is .05 amps. The anticipa-
tor needs to be adjusted to the lowest setting available.
2. When mounting a thermostat on a wall, be sure to follow
your thermostat installation instructions carefully.
NOTE: Thermostat must be mounted level for accu-
rate readings. The thermostat should be mounted on
an inside wall and not in direct line with the appliance
convection air.
NOTE: If the thermostat is located too close to the
appliance, you may need to set the temperature
setting slightly higher to maintain the desired tem-
perature in your home.
3. There is a 4 screw terminal block located on the back
lower left corner of the stove directly above the power
cord inlet. The center 2 screws are for the thermostat
wires.
Shock hazard.
• Do NOT remove grounding prong from plug.
• Plug directly into properly grounded 3 prong
receptacle.
• Route cord away from appliance.
• Do NOT route cord under or in front of appli-
ance.
TERMINAL BLOCK
CENTER 2 SCREWS FOR
THERMOSTAT WIRES
POWER OUTLET
Figure 22.3
7050-128G
Santa Fe Pellet Stove
CAUTION
May 12, 2014