Salt Crystals; Gauge & Switch Panels; Acrylic Plastic Sheeting (Plastic Glass); Canvas And Clear Vinyl - Sea Ray 260 Sundancer Owner's Manual

S
B. S C
ALT RYSTALS
When instruments are exposed to a saltwater
environment, salt crystals may form on the bezel
and the plastic covers. These salt crystals should
be removed with a soft, damp cloth; never use
abrasives or rough, dirty cloths to wipe plastic parts.
Mild household detergents or plastic cleaners can
be used to keep the instruments bright and clean.
REFER TO THE OWNER'S MANUAL PACKET FOR
INSTRUCTIONS AND WARRANTY INFORMATION.
7. G & S
AUGE WITCH
No special care is needed. Just wipe off with a
soft, fresh water damp cloth to remove dust or
salt. Dry after with chamois or soft cloth. Use
of protective chemicals is not required.
NOTE: Do not use any chemicals to clean or
protect gauge lenses.
8. A P
CRYLIC LASTIC
(P G
LASTIC LASS
Never use a dry cloth or duster or glass cleaning
solutions on acrylic.
To clean acrylic, first flood it with water to wash off
as much dirt as possible. Next, use your bare hand,
with plenty of water, to feel and dislodge any caked
dirt or mud. A soft, grit-free cloth may then be used
with a nonabrasive soap or detergent. A soft sponge,
kept clean for this purpose, is excellent. Blot dry
with a clean damp chamois.
Grease and oil may be removed from acrylic with
kerosene, hexane, white (not aviation or ethyl)
gasoline or aliphatic naphtha (no aromatic content).
Do not use solvents such as acetone, silicone
spray, benzine, carbon tetrachloride, fire
extinguisher fluid, dry cleaning fluid or lacquer
thinner on acrylic, since they attack the surface.
Remove fine scratches with fine automotive acrylic
rubbing and polishing compounds.
260 Sundancer (275 Sundancer
®
9 • C
ECTION
P
ANELS
S
HEETING
)
)
®
& R
ARE EFINISHING
9. C
ANVAS AND
Do not fold or store any of the canvas pieces while
wet. All canvas should be rolled or folded when dry and
stored in a clean, dry place. For clear vinyl pieces, the
recommended methods for storage are rolling or laying
down flat. The clear vinyl should never be folded or
creased as cracking will result. To protect the clear vinyl
from rubbing against itself while rolled or stored flat, place
a piece of very soft, nonabrasive cloth between the
pieces. If the surface of the clear vinyl becomes
scratched, the canvas manufacturer has provided a
canvas care sheet located in your Owner's Manual
Packet. When storing the rear (aft) curtain, fold the
canvas over the clear vinyl window (do not fold clear
vinyl), then roll or store flat.
The fabric should be cleaned regularly before substances
such as dirt, pollen, etc. are allowed to accumulate on
and become embedded in the fabric. The fabric can be
cleaned without being removed from the installation.
Simply brush off any loose dirt, particles, etc.; hose down
and clean with a mild solution of a natural soap in
lukewarm water (no more than 100°F, 38°C); rinse
thoroughly to remove soap. DO NOT USE
DETERGENTS. Allow to completely dry.
Wash and clean vinyl windows with a warm soap
solution. Use a soft cloth or sponge and do not scratch
the surface.
If you have stubborn cleaning cases, call your dealer for
proper procedures. Do not try your own cleaning
procedures as they may permanently damage the
canvas.
After each use, especially in salt water areas, rinse the
canvas completely with fresh cold water. Then let the
canvas dry completely before stowing.
All metal components of the canvas should be rinsed
with fresh cold water and exposed components wiped
dry to maintain appearance and working order.
C V
LEAR INYL
9.3