Stains And Scratches; Care For Bottom Paint; Topside Areas; Stainless Steel And Alloy Fittings - Sea Ray 185 Sport Owner's Manual

S
3. S S
TAINS AND CRATCHES
Although gelcoat and painted surfaces are resistant
to deep stains, a need for cleaning will occasionally
arise. But, the use of some common cleaning agents
will permanently discolor or otherwise damage the
finish on your boat.
• Do not use abrasive porcelain-cleaning powders.
These are too abrasive and contain chlorine and
ammonia, either of which will permanently dis-
color gelcoat and paint.
• Never use nail polish remover (acetone) or any
ketone solvents.
• Use diluted household detergents to remove
surface soil and stains. Before using a given
brand, check to make sure it contains no chlo-
rine or ammonia.
• Alcohol can be used to remove difficult stains.
But it must be promptly washed off with mild
detergent and water.
• Minor scratches and deeper stains that do not
penetrate the gelcoat may be removed by light
sanding and buffing.
4. P M
ERMANENTLY
D B
OCKED OATS
If permanently moored in salt water or fresh water,
your boat will collect marine growth on its bottom.
This will detract from the boat's beauty and greatly
affect its performance. There are two methods of
preventing this:
• Periodically haul the boat out of the water and
scrub the bottom with a bristle brush and a solu-
tion of soap and water.
• Paint the hull below the waterline with a good
9.2
9 • C
ECTION
OORED OR
& R
ARE EFINISHING
grade of antifouling paint. DO NOT paint the
engine drive surfaces.
NOTE: There are EPA regulations regarding bottom
paint application. Consult your Sea Ray
proper application methods.
5. C
ARE FOR
From time to time a slight algae or slime forms on
all vessels. The bottom painted portion of the hull
can be wiped off with a coarse Turkish towel or a
piece of old rug while the boat is in the water. Do
not use a stiff or abrasive material to clean the bot-
tom paint.
The bottom paint should be inspected annually. If it
needs repainting consult your Sea Ray
6. T A
OPSIDE
A. S S
TAINLESS
Stainless steel and alloy fittings should be cleaned
with soap and water or household glass cleaner.
Remove rust spots as soon as possible with a
brass, silver or chrome cleaner. Irreversible pitting
will develop under rust that remains for any period
of time. Never use an abrasive like sandpaper or
steel wool on stainless. These may actually cause
rust. To help protect the stainless, we recommend
the use of a good car wax.
B. S C
ALT RYSTALS
When instruments are exposed to a saltwater en-
vironment, salt crystals may form on the bezel and
the plastic covers. These salt crystals should be
removed with a soft, damp cloth; never use abra-
sives or rough, dirty cloths to wipe plastic parts. Mild
household detergents or plastic cleaners can be
used to keep the instruments bright and clean.
REFER TO THE OWNER'S MANUAL PACKET FOR
INSTRUCTIONS AND WARRANTY INFORMATION.
®
B P
OTTOM AINT
®
REAS
A F
TEEL AND LLOY ITTINGS
dealer for
dealer.
185 Sport