Installation Tips; Canvas Care And Maintenance; Horn; Spot Light (Optional) - Sea Ray 260 Sundancer Owner's Manual

S
ECTION
A. I T
NSTALLATION IPS
• Zippers: Zippers are located on each canvas
piece. Make sure canvas is centered over the
metal canvas support rods (bows). When
attaching any canvas piece, zip the zippers only
partially. This helps to hold the piece in place
and relieves tension, helping the other sides zip
or snap easier. After all the sides of the piece
are snapped in place, finish zipping all the
zippers. This will ensure a tight fit.
• Adjustable Support Rods: Adjustable support
rods are located on the Convertible and Bimini
Top. There is an outside tube and an inside tube.
Push in the button to adjust for longer or shorter
rod lengths.
B. C C
ANVAS ARE AND
See Section 9, for instructions on the care and
maintenance of your canvas.
7.18
7 • O
PTIONS
M
AINTENANCE
& A
CCESSORIES
14. H
ORN
E H
LECTRIC ORN
The horn is operated by a momentary switch on
the dash and has a fuse under the dash on the control
station fuse block.
REFER TO OWNER'S MANUAL PACKET FOR
INSTRUCTIONS AND WARRANTY INFORMATION.
15. S L (O
POT IGHT
T O S L
O PERATE THE POT
1. Press POWER button on spot light control pad.
2. Move the toggle switch to direct the spot light.
REFER TO OWNER'S MANUAL PACKET FOR
INSTRUCTIONS AND WARRANTY INFORMATION.
16. U
NDERWATER
The optional swim platform underwater lights are
protected by a fuse on the accessory fuse block.
The lights are activated by pressing UP on the
ACCY switch on the STBD Switch Panel at the
helm.
260 Sundancer
)
PTIONAL
:
IGHT
L (O
IGHTS PTIONAL
(275 Sundancer
®
)
)
®