Setting Edit Points And Playback Speeds - Sony DVCAM DSR-70A Operating Instructions Manual

DMC Editing
Setting Edit Points and Playback
Speeds
Perform the following procedure.
2,4,6,7
REC INHI TC TC SELECT
OFF LOCAL INT
TC MENU
ON REMOTE EXT VITC
ASSEMBLE INSERT
VIDEO AUDIO
1
CH1,1/2 CH2,3/4
AUDIO IN
– +
TRIM
CLIP
LIST MARK
LINK
DELETE ENTRY SHIFT
DELETE
IN OUT
button
PREVIEW REVIEW
AUTO EDIT
AUDIO INPUT
8 PRESET
VARIABLE
PB
AUDIO
PRESET
VARIABLE
3 CH-1 CH-2 CH-3 CH-4
1
Press the ASSEMBLE or INSERT button to select
edit mode.
2
Press the PLAYER/DMC button together with the
ENTRY/SHIFT button.
The PLAYER/DMC indicator flashes and the unit
enters DMC edit mode.
When the playback speed is stored in memory, the
indicator flashes one time per second. When not, it
flashes four times per second.
To exit DMC edit mode
Press the PLAYER/DMC button together with the
DELETE button.
3
Press the RECORDER button.
The RECORDER indicator flashes.
4
To set edit points, press the ENTRY/SHIFT button
together with the IN or OUT button.
88
Chapter 5 Editing
PLAY button
2,5,6,7
REC
PREROLL REC SEQ EDIT
METER
INHI
SET
CH-1/2
z
CH-3/4
EJECT REW PLAY F FWD
TC SERVO STANDBY STOP
Z B x
m M
SHUTTLE JOG
REVERSE FORWARD
VAR
PLAYER RECORDER
DMC
6,9
5
Press the PLAYER/DMC button and set the IN
point for the player.
Note
You cannot set an OUT point for the player.
6
Set the initial playback speed by rotating the
shuttle dial while holding down the PLAYER/
DMC button together with the ENTRY/SHIFT
button.
If you wish to set the initial speed to normal speed,
press the PLAY button.
The set speed is shown in the sub LCD.
7
Once the initial speed has been set, release the
PLAYER/DMC button and ENTRY/SHIFT
button.
8
Press the PREVIEW button.
The tape is prerolled. The recorder tape runs at
normal speed and the player tape runs at its initial
speed.
9
When the search button starts to flash, indicating
that the tape has reached the IN point, rotate the
shuttle dial to the position corresponding to the
desired playback speed.
The variations in playback speed are stored into
memory while the search button is flashing.
When the tape passes the OUT point, the search
button goes out.
If the JOG/SHUTTLE indicator goes out before
the tape passes the OUT point
The unit cannot store any more variations in playback
speed. The capacity of the playback speed memory is
120 seconds.
To amend the stored speed variation
Press the PREVIEW button.
The interval between the speed variation start and end
points is automatically played back at the stored speed.
Operate the search dial as required to adjust the
playback speed.