Sony DVCAM DSR-70A Operating Instructions Manual page 48

Recording
To adjust the output video signal phases
48
Chapter 3 Recording and Playback
5
To stop recording, press the STOP button.
Recording stops.
When long cables are used to connect two cameras to this unit, a slight
shift in phase between the video signals input from the two cameras may
result. When the phase shift is of a significant magnitude, you can detect it
as a picture discontinuity on the LCD monitor at the switch between the
signals from the two cameras.
To align the phases of the video signals from the two cameras, adjust the
phase of the output video signal from one of the two cameras as follows.
1
Holding down the ENTRY/SHIFT button, press the MENU button.
The SYSTEM MENU screen appears on the LCD monitor.
VIDEO PHASE CHECK
LCD monitor
2
1,5
TC TC SELECT
REC INHI
OFF LOCAL INT TC MENU SET
REMOTE EXT
ON VITC
ASSEMBLE INSERT
VIDEO AUDIO TC
CH1,1/2 CH2,3/4
AUDIO IN
– +
TRIM
CLIP
LIST MARK
LINK
DELETE
ENTRY SHIFT
IN OUT
SYSTEM MENU
2
1