Sony DVCAM DSR-70A Operating Instructions Manual page 112

Extended Menu
Item number Item name
AUTOMATIC IN
326
ENTRY AFTER
AUTO EDIT
327 AUDIO MODE
CHANGE
335 OUTPUT
REFERENCE SEL
Item number Item name
401 FUNCTION MODE
AFTER CUE-UP
403 AUTOMATIC
PREROLL
REFERENCE
ENTRY
Item number Item name
501 STILL TIMER
502 TAPE
PROTECTION
MODE FROM
SEARCH
112
Chapter 7 Setup Menu
Menu items in the 300s, relating to editing operations (continued)
Settings
Select whether or not to automatically set the OUT point of the previous edit as the next
IN point at the end of an automatic edit.
OFF : No automatic setting.
R: Set recorder IN point automatically.
R & P: Set recorder IN point automatically, and also player IN point in two-VCR editing.
Select whether to allow audio data recorded on tape in two-channel mode (or four-
channel) to be re-recorded in four-channel (or two-channel mode).
OFF: Do not allow re-recording in a different audio mode.
ON: Allow re-recording in a different audio mode.
Select the reference video signal to use.
REF: Use the signal input to the REF. VIDEO IN connector as the reference video
signal. The input video signal to be edited is required to be in synchronization with the
reference video signal.
VIDEO: Use the input video signal as the reference video signal.
Menu items in the 400s, relating to preroll
Settings
Select the state that the unit goes into after a cuing-up operation.
STOP: Stops (the STOP mode).
STILL: Still playback (in search mode).
Select whether or not the edit IN point is automatically set by pressing the PREROLL
button when the IN point is not set before starting preroll.
DIS: IN point is not set automatically.
ENA: IN point is set automatically.
Menu items in the 500s, relating to tape protection
Settings
Select the time delay from the tape transport stopping (either the "STOP" mode or the
still playback mode in search mode) until the unit automatically switches to the tape
protection mode, in order to protect the rotary heads and the tape.
0.5S... 1M ...5M: Set the value in the range 0.5 seconds to 5 minutes.
Select the type of tape protection to use when switching from still playback in search
(jog/shuttle) mode to tape protection mode.
STEP: Step forward at 0.03 times normal speed for 2 seconds.
STDBY: Switch to Standby OFF mode (the unit not on standby).