Modifying Edit Points; Setting Edit Points Using The Recorder Only - Sony DVCAM DSR-70A Operating Instructions Manual

Modifying Edit Points

Once you set edit points, you can delete them or
modify them as required in units of one frame.
When edit points have been set incorrectly, for
example when an OUT point is located before an IN
point or when the durations of editing segments on the
player and recorder do no match, the DELETE buttons
flash to alert you that a preview or edit cannot be
conducted. Correct the edit points as required.
To delete an edit point
Proceed as follows.
AUDIO IN
–
TRIM
CLIP
LIST MARK
LINK
DELETE ENTRY SHIFT
IN OUT
Press the flashing DELETE button together with the
IN button or the OUT button.
The DELETE button stops flashing, and the edit point
is deleted.
+
DELETE button
OUT button
IN button
To modify edit points slightly
Proceed as follows.
AUDIO IN
– +
TRIM
CLIP
LIST MARK
LINK
DELETE ENTRY SHIFT
IN OUT
1
While pressing the recorder side or player side IN
or OUT button, depending on the edit point that
you want to modify, press a TRIM button (+/
MARK or –/LIST) on the same side of the control
panel.
The edit point time data is displayed.
Each time you press the +/MARK button, you
advance one frame, and each time you press the –/
LIST button you return one frame.
2
After making the modifications, press the IN or
OUT button that you pressed in step 1.
Setting Edit Points Using the
Recorder Only
If you press the PLAYER/DMC button to light the
PLAYER/DMC indicator on the control panel, you can
operate the player or an external VCR with the
recorder side buttons, and set edit points.
In this case, it is recommended that you set setup menu
item 006 "LOCAL FUNCTION ENABLE" to ST&EJ
(default setting) on the player beforehand (see page
104).
TRIM+/MARK and
–/LIST buttons
OUT button
IN button
83
Chapter 5 Editing