Digitally Dubbing Signals In Dvcam Format (Optional Dsbk-140/150/160A Required) - Sony DVCAM DSR-70A Operating Instructions Manual

Digitally Dubbing Signals in DVCAM Format
(Optional DSBK-140/150/160A Required)
50
Chapter 3 Recording and Playback
In addition to straightforward tape dubbing, you can also use this unit to
digitally dub signals in DVCAM format automatically from the beginning
of the tape to the end, through an i.LINK or SDTI(QSDI) interface.
When a tape recorded on a DSR-1/1P Digital Videocassette Recorder or
DSR-300/300P Digital Camcorder is dubbed, the ClipLink log data held in
the cassette memory is also copied.
To use an i.LINK interface requires the optional DSBK-140 or DSBK-
160A board, and to use an SDTI(QSDI) interface requires the optional
DSBK-150.
For information about connections and basic settings, see "Connections for
Digitally Dubbing Signals in DVCAM Format" (page 131).
Notes
• Use a tape which is recorded in the DVCAM format. A tape recorded in
DV format cannot be used as a source tape for dubbing through an
SDTI(QSDI) or i.LINK interface.
• Regardless of the audio recording mode setting of this unit, dubbing is
performed with the original audio recording mode unchanged (two-
channel mode (48 kHz) or four-channel mode (32 kHz)).
• Approximately the last 2 minutes of the tape may not be copied because
of differences in tape lengths. (If an Index Picture is recorded in this
portion, it may also not be copied.)
• A continuous recorded section of approximately 5 seconds is required
before the recording start point. It is recommended to record beforehand
color bars or a similar signal at the start point of the source tape to be
dubbed on this unit.
Perform the following procedure.
1,7
TC SELECT
REC INHI TC
OFF LOCAL INT
TC MENU SET
ON REMOTE EXT VITC
ASSEMBLE INSERT
VIDEO AUDIO TC
CH1,1/2 CH2,3/4
AUDIO IN
– +
TRIM
CLIP
LIST MARK
LINK
DELETE ENTRY SHIFT
IN OUT
3
2,5
1