ADTRAN TSU LT User Manual page 48

Hide thumbs Also See for TSU LT:

Table of Contents

Chapter 5. Configuration Menu

DATA RATE

Selects the data rate for the control port. This should be consistent with all units on a chain and with

the modem and/or PC/Proxy Agent serial port.

Choices: 1200, 2400, 9600

ALARMS

Used to initialize the method by which the control port handles alarm conditions.

TRAPS

Determines if alarm conditions should automatically send alarm messages (traps) to the controlling

PC/Proxy Agent. The setting is for this unit, or for slaves if this unit is a master.

Choices: ENA, DISA

For applications where the

with the Inband selection set to

OUTPUT

Selects whether the alarm traps (if enabled) are sent directly, or if the telephone number stored in the

TSU LT should be dialed first (industry-standard AT dial command sent to modem).

Choices: DIRECT, DIAL

TEL NUM

This is the telephone number which is dialed to obtain alarm traps. The string can be up to 20

characters in length and is terminated with a semicolon (;) as the last character. A colon (:) character is

used to represent a pause in the dial string.

For example, for number 9:5551212; dial 9, pause momentarily and then dial 5551212. This pause

could be necessary to access an outside line, such as a PBX.

When editing a specific character, the arrows are used to scroll from 0 to 9, then colon (:) and

semicolon (;). The new telephone number is entered into the TSU LT only upon pressing Enter after

typing the semicolon.

Choices: 20 digits (0-9, :, and ;)

The typed digits are accepted only after pressing Enter.

selection is not acceptable,

UTO

NBAND

TSU LT User Manual

should only be enabled

RAPS

61202060L4-1

Table of Contents