Install Indoor Unit - Gree GWH09AB-A3DNA1B Service Manual

7.3 Install Indoor Unit

7.3.1 Installation of Mounting Plate
1.Make the mounting plate completely level . As the water tray's oulet of the indoor unit is two-way type, the indoor unit during
installation should slightly slant to watert tray's outlet for smooth drainage of condensing water.
2.Fix the mounting plate on the wall with screws.(Where is pre-covered with plastic granula)
3.Be sure that the mounting plate has been fixed firmly enough to withstand the weight of an adult of 132.3 lb.; further more,
the weight should be evenly shared by each screw.
7.3.2 Drill Piping Hole
1.Slant the piping hole (
2.Insert the piping-hole sleeve into the hole to prevent the connection piping and
wiring from being damaged when passing through the hole.
7.3.3 Installation of Drain Hose
1.Connect the drain hose to the outlet pipe of the indoor unit.Bind the joint with
rubber belt.
2.Put the drain hose into insulating tube.
3.Wrap the insulating tube with wide rubber belt to prevent the shift of insulating
tube. Slant the drain hose downward slightly for smooth drainage of condensing
water.
Note: The insulating tube should be connected reliably with the sleeve out-
side the outlet pipe. The drain hose should be slanted downward slightly,
without distortion, bulge or fluctuation. Do not put the outlet in the water.
Wall
Mark on the middle of it
Space
to the
wall
5 .9 in.
above
Left
Φ 2.2 in.
(Rear piping hole)
Wall
Mark on the middle of it
Space
to the
wall
5.9 in.
above
Left
Φ2.2 in.
(Rear piping hole)
5.9) on the wall slightly downward to the outdoor side.
Gradienter
Space
to the
wall
5.9 in.
above
Right
Φ 2.2 in.
(Rear piping hole)
09K Unit
Gradienter
Space
to the
wall
5.9 in.
above
Right
Φ 2.2 in.
(Rear piping hole)
12K Unit
Fig.5
26
Wall
Wall
Indoor
Outdoor
Wall pipe
Seal pad
outlet pipe of
indoor unit
outlet pipe of
drain hose
indoor unit
rubber belt
outlet pipe of
drain hose
indoor unit
rubber belt
insulating tube
rubber belt
outlet pipe of
indoor unit
insulating tube
connected
bulge
distortion
Flooded
Installation Manual
Ø2.2