Freezer Drawer Slide Assemblies - GE Adora DFE29JG Technical Service Manual

Freezer Drawer Slide Assemblies

The freezer drawer utilizes 2 closure mechanisms
that automatically pull the drawer shut when it is
within 1 inch of the closed position. The mechanisms
are built into the 2 freezer drawer slide assemblies
and are not replaceable as a separate part.
Freezer Drawer Closure Mechanism
The freezer drawer is inserted into alignment slots (1
on each side) and attached to the slide assemblies
with 6 bolts (3 on each side).
To remove the freezer drawer slide assemblies:
1. Remove the freezer drawer front. (See
.)
Drawer Front
2. Remove the plastic clip from the crossbar.
Plastic Clip
Crossbar
3. Pull the crossbar to the right then remove it from
the right-side drawer gear.
Note: The procedure to remove both drawer slide
assemblies is similar.
4. Remove the three T-20 Torx screws from the
drawer bracket.
5. Lift the drawer bracket from the slide assembly.
6. Pull the drawer slide out to the stop position.
7. Remove the two T-20 Torx screws from the
drawer slide.
8. Press in the lock tab and pull the drawer slide
Freezer straight out from the slide holder.
9. Remove the 4 recessed 1/4-in. hex-head screws
from the slide holder.
10. Pull the slide holder out from the freezer wall.
– 53 –
Drawer Bracket
Slide Holder
Drawer Slide
Lock Tab