Blower Replacement - Heatilator ECO-WINS18 Owner's Manual

D. Blower Replacement
1. Remove surround from unit.
2. Using a phillips head screwdriver, remove 8-32 screw,
washer and bushing assemblies holding left side panel
in place. Remove panel.
3. Disconnect the wires from the blower.
4. Remove three wing nuts as shown. Figure 22.1
5. Remove blower assembly from unit
6. Using phillips head screwdriver, remove two 8-32 sheet-
metal holding the blower mount bracket to the blower
shield. Figure 22.2
7. Remove four 8-32 machine screws holding blower to
blower mount bracket.
8. Re-install in reverse order. Be certain that the hold down
bracket's screws are completely seated in the grom-
ments and insulation board is place properly.
WING NUTS
Figure 22.1
22
Figure 21.1
Heatilator • ECO-WINS18 • 7065-132 • June 13 2011
8-32 MACHINE
SCREWS
(x4)
8-32 SHEET-
METAL
SCREWS
(x2)
Figure 22.2
CAUTION
Shock Risk.
• Do NOT remove grounding prong from plug.
• Plug directly into properly grounded 3 prong
receptacle.
• Route cord away from appliance.
• Do NOT route cord under or in front of appliance.
WARNING
Fire Risk.
Do NOT allow hot coals or embers to overfl ow ash lip
• May melt protective wire coating on fan power
cord causing electrical short, fi re or injury
BLOWER MOUNT
BRACKET
BLOWER SHIELD