Congratulations; Sample Of Safety/Serial Number Label - Heatilator ECO-WINS18 Owner's Manual

Eco-choice wood burning insert
Hide thumbs Also See for ECO-WINS18:
Table of Contents

Advertisement

Read this manual before installing or operating this appliance.
Congratulations on selecting a Heatilator wood burning
appliance. The wood burning appliance you have selected
is designed to provide the utmost in safety, reliability and
effi ciency.
As the owner of a new wood burning appliance, you'll want
to read and carefully follow all of the instructions contained
in this owner's manual. Pay special attention to all cautions
and warnings.
NOTE: Clearances may only be reduced by means
approved by the regulatory authority having jurisdiction
Test Lab & Report
Number
2
Please retain this owner's manual for future reference.
SAMPLE OF SERIAL NUMBER / SAFETY LABEL
LOCATION: UNDER ASH LIP, PULL OUT TO VIEW
CAUTION:
BURNS. SEE NAMEPLATE AND INSTRUCTIONS.
ATTENTION:
L'INSTALLATION. LE CONTACT PEUT CAUSER DES BRÛLURES À LA PEAU. VOIR
L'ÉTIQUETTE ET LES INSTRUCTIONS.
W/N 20514
ETL4001508
Tested to / Testé a:
UL 1482, ULC S628-93
LISTED ROOM HEATER, SOLID FUEL TYPE. "For Use with Solid Wood Fuel Only."
Also For Use In Mobile Homes
PREVENT HOUSE FIRES
I
nstall and use only in accordance with manufacturer's installation, venting and
operating instructions.
CONTACT YOUR LOCAL BUILDING OR FIRE OFFICIALS ABOUT
RESTRICTIONS AND INSTALLATION INSPECTION IN YOUR AREA.
Refer to manufacturer's instructions and local codes for precautions required for
passing chimney through a combustible wall or ceiling.
When used as a masonry insert stove, install only in a masonry fireplace built to
national and/or local codes. Do not remove brick or mortar to accommodate
insert. Installation requires minimum of a starter pipe into existing chimney with
airtight face seal.
Install only on a non-combustible hearth. Approved for installation and use in
factory built zero-clearance fireplaces conforming to minimum fire chamber
specifications, follow instructions in the owner's manual.
Components required for installation: listed vent liner only.
In Canada a full length 6
inch
(152mm) S635 flue liner is required as per ULC
S628-93.
WARNING - Inspect and clean chimney frequently. Under certain conditions of
use, creosote buildup may occur rapidly.
Do not connect this unit to a chimney serving another appliance.
DANGER: Risk of electrical shock. Disconnect power supply before servicing.
Route power cord away from unit.
Do not route cord under or in front of
appliance.
Electrical Rating: 115 VAC .63 AMPS 60 Hz
Do not use grate or elevate fire. Build wood fire directly on hearth(firebrick).
Do not overfire. If heater or chimney connector glows, you are overfiring.
Operate only with doors closed. Open only to add fuel to the fire.
Replace glass only with 5mm ceramic available from your dealer.
OPTIONAL COMPONENTS: Mantel Deflector, Part MNTL-18-DFLCTR
Maximum Mantel Depth - 11.5" (292mm)
Profondeur Maximum de la Manteau de Cheminée - 11.5"
(292mm)
Mantel
/
Manteau de Cheminée
B
Fascia or Trim
Panneau ou Moulure
C
A
Fuel
Door
F
Extension de l'âtre
Hearth Extension /
Manufactured by /
Fabriqué par:
U.S. ENVIRONMENTAL PROTECTION AGENCY - Certified to comply with July 1990 particulate emission standards.
2011 2012 2013 JAN FEB MAR APR MAY JUN JUL AUG SEP OCT NOV DEC
1445 N. Highway, Colville, WA 99114
www.heatilatorecochoice.com
Heatilator • ECO-WINS18 • 7065-132 • June 13 2011

Congratulations!

This owner's manual should be retained for future refer-
ence. We suggest you keep it with your other important
documents and product manuals.
Your new wood burning appliance will give you years of
durable use and trouble-free enjoyment. Welcome to the
Heatilator family of wood burning products!
HOT WHILE IN OPERATION DO NOT TOUCH, KEEP CHILDREN,
CLOTHING AND FURNITURE AWAY. CONTACT MAY CAUSE SKIN
CHAUD LORS DE L'OPÉRATION. NE PAS TOUCHER. GARDEZ LES
ENFANTS ET LES VÊTEMENTS LOIN DE L'ESPACE DÉSIGNÉ DE
Model / Modèle:
ECO-WINS18
WOOD INSERT
APPAREIL DE CHAUFFAGE DE PIÈCE, DE TYPE DE COMBUSTIBLE SOLIDE.
PRÉVENTION DES FEUX DE MAISON
Installez et utilisez en accord avec les instructions d'installation et d'opération du fabricant. Contactez le
bureau de la construction ou le bureau des incendies au sujet des restrictions et des inspections d'installation
dans votre voisinage.
Référez vous aux instructions du fabricant et des codes locaux pour les précautions requises pour passer une
cheminée à travers un mur ou un plafond combustibles, et les compensations maximums.
Lorsque vous utilisez un poêle inséré fabriqué en briques, installez un foyer en briques fabriqué selon des
codes national et/ou locaux. Ne pas enlever de la brique ou du mortier pour accommoder la pièce insérée.
L'installation demande un tuyau allant de la cheminée existante avec un couvert hermétique.
Installez seulement sur un foyer incombustible. Approuvé pour l'installation et l'usage dans les cheminées
avec espace libre de zéro, fabriquées en usine et se conformant aux spécifications minimum de chambre de
feu.
Composants requis pour l'installation: aération homologué revêtement seulement.
Au Canada, un tuyau doublé de grandeur de 6
ATTENTION! Inspectez et nettoyez la cheminée fréquemment. Sous certaines conditions, il se peut que la
créosote s'accumule rapidement.
Ne pas connecter cet appareil à une cheminée servant un autre appareil.
DANGER: Il y a risque de décharge électrique. Déconnectez le fil électrique de la prise de contact avant le
service.
Éloignez le fil électrique de l'appareil. Ne pas faire passer le fil électrique au dessus ou en dessous de
l'appareil.
Puissance Électrique: 115 VAC, .63 Amps, 60 Hz.
N'élevez pas le feu. Bâtissez le feu de bois directement sur l'âtre.
Ne pas surchauffer. Si l'appareil de chauffage ou le tuyau de cheminée rougissent, vous surchauffez.
Opérez l'appareil seulement lorsque la porte de chargement est fermée. Ouvrez la porte seulement lorsque
vous devez ajouter des combustibles dans le feu.
Remplacez la vitre seulement avec une vitre céramique de 5 mm disponible chez votre fournisseur.
PIÈCES OPTIONNELLES: Déflecteur de cheminée d Piéce 7044-214
Minimum Clearances To Combustible Material
Espaces Libres Minimum Des Matériaux Combustibles
Masonry, Heat Exchanger & Zero
Clearance
En briques, Circulant la chaleur &
d'espace libre
MANTEL CLEARANCES
Espace Libre Manteau de Cheminée
/
No Mantel Deflector
Pas de protection de cheminée
with Mantel Deflector
avec un déflecteur de cheminée
FLOOR PROTECTION /
PROTECTION DU PLANCHER
Floor height 0" to 7" (0 to 178mm) below Insert Base
Hauteur du sol de 0" à 7" (0 à 178mm) sous la base de l'insert
D
Floor height greater than 7" (178mm) below Insert Base
Hauteur de sol supérieure à 7" (178mm) sous la base de l'insert
THERMAL PROTECTION / Protection Thermique
Floor height 0" to 7" (0 to-178mm) below Insert Base
Hauteur du sol de 0" à 7" (0 à 178mm) sous la base de l'insert
E
Floor height greater than 7" (178) below Insert Base
Hauteur de sol supérieure à 7" (178) sous la base de l'insert
DO NOT REMOVE THIS LABEL / NE PAS ENLEVER L'ÉTIQUETTE
Serial No / Numéro De Série
007026
inch
(152mm) S635 est exigé par le code ULC
S628-93.
États-Unis
CANADA
USA/
A
B
C
D
A
B
C
D
18"
18"
n/a
n/a
18"
n/a
n/a
18"
(457)
(457)
(457)
(457)
26"
18"
26"
18"
n/a
(457)
n/a
(660)
(457)
n/a
n/a
(660)
21.25"
18"
21.25"
18"
n/a
(457)
n/a
(540)
(457)
n/a
n/a
(540)
/États-Unis
CANADA
USA
E
F
E
F
16"
18"
8"
12"
(406)
(203)
(457)
(305)
12"
16"
8"
18"
(305)
(406)
(457)
(203)
États-Unis & Canada
USA/
1 inch (25) of k=0.47, R = 2.13
Only ember protection required
Made in U.S.A.
of US and
imported parts.
Fabriqué aux
États-Unis-d'Amérique par des
pièces d'origine américaine et
pièces importées.
7065-134
Serial Number
Model Name
Mfg Date

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents