Graco ST Max 395 Quick Operator's Manual

WARNING
SETUP
Connect hose to sprayer and gun.
Tighten hose connections with wrench.
Turn prime valve Place siphon tube in pail
to Prime position (down). partially filled with water.
Aim gun at inside
Make sure safety wall of water pail
lever of gun is OFF. and squeeze trigger.
Keeping gun triggered into water
Increase pressure until
pail, turn prime valve
sprayer starts and paint
to Spray position (horizontal).
comes out of drain tube.
CHOOSE THE RIGHT TIP & FILTER
109 111
207 209 211
307 311
309
411
409
511
509
611
609
pump filter 200 mesh
gun filter 100 mesh
www.graco.be
ST Max ™
ST Max ™
Quick Operator's Guide
Unscrew tip & guard from gun.
Turn pressure control knob
to lowest pressure, and set
power switch to ON.
Increase pressure until
sprayer starts. Keep gun
triggered into water pail for
1 minute. Release trigger.
When paint comes out of gun,
release trigger and turn safety
lever of gun to ON.
113 115 121
119
213 215 217 221 223
219
313 315 317 321 323
319
415 417 421 423
413 419
515 517 521 523
513 519
615 617 621 623
613 619
721 723
815 817 821
819
917
100 mesh 60 mesh
100 mesh
60 mesh
395
II 495/595
This procedure is for water-base paints and flushing fluids. For solvent-base paints and flushing
fluids (i.e. mineral spirits), you must read Fire and Explosion Hazard in the Operating Instructions.
* check the Graco operations manual delivered with the unit for more details.
Fill throat packing nut with TSL ™
to prevent premature packing wear.
Increase pressure until
sprayer starts and water
runs out of prime tube.
Let water run out of prime
tube for 15 seconds.
Turn prime
valve to Prime
position (down).
Transfer drain
tube to paint pail.
Texture material
for spray applications
225 235
325 327
331
425 427 433 435
429
525 527 533 535
529 531
625 633 635
627 629 631
725 735
729
835
827 831 833
935
30 mesh
Make sure power Plug electrical cord
into grounded outlet.
switch is set to OFF.
Turn prime valve
Decrease pressure to Spray position
until sprayer stops. (horizontal).
Aim gun at inside
Place siphon tube in paint
pail, but leave drain tube wall of water pail,
and squeeze trigger.
in water pail.
Screw tip & guard onto gun, making sure
arrow-shaped handle of tip is pointing forward.
You can reverse this tip to quickly clear clogs
without taking it apart.
NEW
st
1 digit X5
fan width
=
5 cm
10 cm
15 cm
439 443 451 455 20 cm
543 551 555 25 cm
645 655 30 cm
35 cm
40 cm
45 cm
none
none
* at 30 cm spraying distance
WORN
Time to
change!
*
3 cm
7 cm
10 cm
15 cm
20 cm
25 cm
30 cm
35 cm
40 cm