Graco ST Max 395 Quick Operator's Manual

ST Max
ST Max
Quick Operator's Guide
WARNING
SETUP
Connect hose to sprayer and gun.
Tighten hose connections with wrench.
Turn prime valve Place siphon tube in pail
to Prime position (down). partially filled with water.
Aim gun at inside
Make sure safety wall of water pail
lever of gun is OFF. and squeeze trigger.
Keeping gun triggered into water
Increase pressure until
pail, turn prime valve
sprayer starts and paint
comes out of drain tube. to Spray position (horizontal).
CHOOSE THE RIGHT TIP & FILTER
109 111 113
207 209 211 213
307 311 313
309
409 411 413
509 511 513
609 611 613
pump filter 200 mesh
100 mesh
gun filter 100 mesh
100 mesh
www.graco.be
™ 395
™ II 495/595
This procedure is for water-base paints and flushing fluids. For solvent-base paints and flushing
fluids (i.e. mineral spirits), you must read Fire and Explosion Hazard in the Operating Instructions.
* check the Graco operations manual delivered with the unit for more details.
Fill throat packing nut with TSL
Unscrew tip & guard from gun. to prevent premature packing wear.
Turn pressure control knob
to lowest pressure, and set
power switch to ON.
Increase pressure until
sprayer starts. Keep gun
triggered into water pail for
1 minute. Release trigger.
When paint comes out of gun,
release trigger and turn safety
lever of gun to ON.
115 119 121
215 217 219 221 223 225
315 317 321 323 325 327
319
415 417 421 423
419 425 427
515 517 519 521 523 525 527
615 617 619 621 623 625 627
721 723 725
815 817 821 827
819
917
60 mesh 30 mesh
60 mesh
™ Make sure power
switch is set to OFF.
Increase pressure until
sprayer starts and water
runs out of prime tube.
Let water run out of prime
Decrease pressure
tube for 15 seconds. until sprayer stops.
Turn prime Place siphon tube in paint
valve to Prime
pail, but leave drain tube
position (down). in water pail.
Screw tip & guard onto gun, making sure
arrow-shaped handle of tip is pointing forward.
Transfer drain
You can reverse this tip to quickly clear clogs
tube to paint pail.
without taking it apart.
Texture material
for spray applications
235
331
435 439
429 433 443
529 531 533 535 543
629 631 633 635 645
729 735
833 835
831
935
none
none
Plug electrical cord
into grounded outlet.
Turn prime valve
to Spray position
(horizontal).
Aim gun at inside
wall of water pail,
and squeeze trigger.
NEW WORN
1 st digit X5 Time to
fan width change!
= *
5 cm 3 cm
10 cm 7 cm
15 cm 10 cm
451 455 20 cm 15 cm
551 555 25 cm 20 cm
655 30 cm 25 cm
35 cm 30 cm
40 cm 35 cm
45 cm 40 cm
* at 30 cm spraying distance