How Does It Work; Installation - Marmitek Powermid 300 XTRA User Manual

Marmitek powermid 300 xtra extender user manual

Table of Contents

Available languages

3. HOW DOES IT WORK?

IR RECEIVER

Point your remote control at the Powermid 300 XTRA™ IR Receiver. The IR Receiver receives

these infrared signals, converts them into RF signals and sends them onto the Powermid 300

XTRA™ IR Transmitter. The IR Transmitter then converts these back into infrared signals and

sends them to your HDD-recorder, set-top box, satellite decoder, audio set, etc.

4.1 IR Receiver

1. Place the IR Receiver in the room/area from which you wish to operate your equipment.

2. Point the front of the IR Receiver towards the point at which you want to use the remote

control (maximum 6 metres).

3. The IR Receiver is dual power:

a. with batteries (included)

Insert 2 pieces 'AAA' size ALKALINE batteries into the battery compartment with

correct polarity. Note: Remove the batteries when they are empty or if you are not

using the device for a longer period.

b. With micro USB cable (not included)

Connect the micro USB cable to the IR Receiver.

4.2 IR Transmitter

4. Place the IR Transmitter in the room/area in which the A/V equipment you wish to operate

is located.

5. Point the front of the IR Transmitter towards the equipment you wish to operate.

6. Connect the USB Power Adapter to the IR Transmitter and insert this into the socket.

4.3 Range between Transmitter and Receiver depends on:

• The number of floors and walls through which the signal has to travel and the materials used.

• Other 433 MHz sources such as wireless headphones or wireless speakers can significantly

limit the range of the Powermid 300 XTRA™. The best result is obtained if these sources

are switched off when using the Powermid 300 XTRA™. The Powermid 300 XTRA™ works

fine with wireless telephones.

WALL

IR TRANSMITTER

HD RECORDER

SET-TOP BOX

SATELLITE

AUDIO SET

Table of Contents