Identification Of Parts; Freestanding Operation - Dimplex DXDH10T Installation And Operating Instructions Manual

Identification of Parts

Wall-mounting instruction:
A wall mounting bracket is supplied on the back of the heater for installation.

Freestanding Operation

The unit must be placed on a stable, level and horizontal surface , otherwise
water may leak out when operating.
NOTE: When in use you must ensure that the air inlet and air outlet of the
appliance are not obstructed
Fitting the Water Tank:
The water tank must be fitted properly. When the tank is full or is not in place
correctly the" FULL" indication lights and the unit stops or won't start operating.
Set the wall plate against the wall so that the unit will
have a floor clearance of at least 150cm. Ensure it is
horizontal and mark the 2 fixing locations through the
keyhole slots on the plate.
Remove plate and drill 2 x 6mm diameter holes 20mm
deep and fit the wall plugs supplied, realign the plate
and fit the 2 screws supplied tightly in position.
Note that 4 additional holes are provided and one or
all can be used to permanently fix with steel nails.
The appliance is now simply hung onto the bracket by
aligning the back panel location to the wall plate and
dropping the product onto the plate while pushing it
against the wall to ensure it locates properly.