Table of Contents
Advertisement
OPTIONAL ACCESSORIES
3. Use one 90° angle trim bracket to join the corner of
one piece of side trim to the corner of the top trim
piece. Figure 37. A rubber hammer or handle of a claw
hammer will help secure the corners.
4. Repeat for other side.
NOTE: If you do not attach the trim at the correct
corners, use a hammer and screwdriver to tap on the
one end of the 90° angle bracket. This will separate the
two pieces of trim. Figure 38
5. Place assembled black trim on front of heater. Using four
(4) black screws, secure black trim to sides of heater.
Figure 38
Black Trim
Black Screw
Figure 38 -
Attach Assembled Trim to Fireplace
BLACk TRIM INSTALLATION
32VFSC
FP2524
1. Remove trim from protective packaging. Be careful not
attach trim
to scratch the trim. Remove two () 90° angled mounting
brackets and two () 90° angled shims.
. Lay trim face down on the floor. Line up the 45°-angled
corners of the top trim with the 45°-angled corners of
the side trims.
NOTE: Both ends of the top piece of trim are mitered.
Figure 39
3. Slide one (1) 90° angled bracket (with attached screws)
and one (1) 90° angled shim in the outside corner slot
where the top and side trims meet. Figure 40
33D4051
Figure 39 -
Align Corners of Trim Pieces
Bracket
Shim
FP54
Figure 40 -
Secure Corners
4. Hold the corners together securely. Tighten screws on
Holes for Black
bracket with flat head screwdriver. Make sure the cor-
Screws
ners are flush and there are no spaces. Do not over
tighten screws. Figure 40
5. Repeat for other side trim.
6. Slide assembled trim over the top and down the sides of
the fireplace. Flush trim with front of fireplace as shown
in Figure 41.
7. Align holes in assembled trim with holes in side of fire-
place. Using a Phillips screwdriver, attach trim with four
(4) screws provided — two for each side of fireplace.
Tighten snuggly. Figure 42
VFS & DBX Series Vent Free Fireplaces
45° Angled
Corners
Back of Trim
Assembly
FP2525
mitered corners
Outside
Corner Slot
FP2526
secure corners
FP55
Bracket
Screws
No Spaces
Where Corners
Join
Ensure Corners
are Flush
FP56
33
Advertisement
Table of Contents
