Advertisement
WARNING: TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING:
1.
Installation work and electrical wiring must be done by qualified person(s) in accordance with all applicable codes and standards(ANSI/NFPA 70-
1993), including fire-rated construction.
2.
Use this unit only in the manner intended by the manufacurer. If you have any questions contact the manufacturer.
3.
After making the wire connections, the wires should be spread apart with the grounded conductor and the equipment-grounding conductor on
one side of the outlet box and ungrounded conductor on the other side of the outlet box.
4.
Before you begin installing the fan, Switch power off at Service panel and lock service disconnecting means to prevent power from being
switched on accidentally. When the service disconnecting means cannot be locked, securely fasten a prominent warning device, such as a tag,
to the service panel.
5.
Be cautious! read all instructions and safety information before installing your new fan. Review the accompanying assembly diagrams.
6.
When cutting or drilling into wall or ceiling, do not damage electrical wiring and other hidden utilities.
7.
Make sure the installation site you choose allows the fan blades to rotate without any obstructions. Allow a minimum clearance of 7 feet from the
floor to the trailing edge of the blade.
8.
To reduce the risk of fire, electric shock, or personal injury, mount to outlet box or supporting system acceptable for fan support and use
mounting screws and washers provided with the outlet box.
9.
Do not bend blade holders during installation to motor, balancing or during cleaning. Do not insert foreign object between rotating blades.
10.
Attach the mounting bracket using only the hardware supplied with the outlet box.
11.
To reduce the risk of fire or electric shock, do not use this fan with any solid state fan speed control device, or variable speed control.
12.
If this unit is to be installed over a tub or shower, it must be marked as appropriate for the application.
13.
NEVER place a switch where it can be reached from a tub or shower.
14.
The combustion airflow needed for safe operation of fuel-burning equipment may be affected by this unit's operation. Follow the heating
equipment manufacturer's guideline safety standards such as those published by the National Fire Protection Association (NEPA), and the
American Society for Heating, Refrigeration and Air Conditioning Engineers (ASHRAE) and the local code authorities.
15.
Before servicing or cleaning unit, Switch power off at Service panel and lock service disconnecting means to prevent power from being switched
on accidentally. When the service disconnecting means cannot be locked, securely fasten a prominent warning device, such as a tag, to the
service panel.
Phillips Screwdriver
Unpack and inspect fan carefully to be
1
certain all contents are included. (See
exploded view parts list.)
Install mounting bracket to outlet box in
4
ceiling using the screws provided with
the outlet box and washers.
I
NSTALLATION
Safety Tips
READ AND SAVE THESE INSTRUCTIONS
(Mounting must support at least 35 lbs.)
TOOLS REQUIRED
Wire Cutters
2
Turn off power at breaker box to avoid
possible electrical shock.
Cotter
Pin
Clevis
Pin
Feed motor lead wires through downrod/
canopy assembly and insert downrod into
motor yoke. Next, insert clevis pin through
yoke and downrod and secure with cotter
5
pin. (see inset) Tighten both yoke set
screws to further secure downrod.
Page 2 – Designer Supreme-English CUL
Pliers
Step Ladder
Use outlet box suitable for fan support.
Secure outlet box directly to the building
3
structure using ceiling joist screws. Outlet
box must support 35 lbs.
Ball
Ridge
Notch
Set
Screws
Carefully lift fan assembly onto mounting
bracket. Rotate fan so that the notch on
the ball engages the ridge in the
6
mounting bracket. This will allow hands-
free wiring.
Advertisement
