Advertisement
12
Side cover
Remove side covers from canopy
exposing 4 holes. 2 closed holes and 2
open "L" shape holes.
15
To prepare the fan for wiring, hang fan
onto mounting bracket by sliding the
canopy over the mounting bracket hook
(Use one of non-slotted holes on the
rim of the canopy).
© 2015 Monte Carlo Fan Company
13
Place canopy and rubber pad over lead
wire and safety cable and align the larger
holes in canopy and holes on rubber pad
with the set screws on yoke.
SAFETY CABLE INSTALLATION
16
Hook
Lag screw
Safety cable
Washer
Lock washer
For Canadian installation and for USA fan
and light kit combinations over 35 lbs, in
both flush and downrod modes the safety
cable must be installed into the house
structure beams using 3" lag screws,
washers and lock washers provided.
Make sure that when the safety cable is
fully extended the lead wires are longer
than the cable and no stress is placed on
the lead wires.
Note
: If Installing The Secondary Support
Safety Cable in the U.S., Do Not Remove
Knockouts In The Outlet Box.
14
Rubber pad
Reinstall the 3 set screws remove in step
11. Tighten screws securely.
17
Power
source
Black
(Live)
Make wiring connections using wire
connectors provided as indicated above.
White from fan to White (Neutral) from
house . Black and Blue from fan to Black
(Live) from house. Connect all green
grounded wires to Grounded wire from
House. Make sure that no filaments are
outside of the wire connectors.
5
White
Wall
(Natural)
switch
Grounded/
Green
Black
Blue
White
5/10/2015
Advertisement
