Advertisement
Canadian Mounting System Insert
Cotter
Pin
Clevis
Pin
Feed motor lead wires through downrod/
canopy assembly and insert downrod into
motor yoke. Next, insert clevis pin through
yoke and downrod and secure with cotter
1
pin. (see inset) Tighten both yoke set
screws to further secure downrod.
4
Set
Screws
While the fan assembly is still on the
2
ground thread the safety cable through
the mounting bracket.
Install mounting bracket to outlet box in
ceiling using the screws provided with the
outlet box and washers.
WARNING: MOUNT ONLY TO AN OUTLET BOX MARKED
ACCEPTABLE FOR FAN SUPPORT
All set screws must be checked and retightened where
necessary before installation.
safety cable
mounting
bracket
Ridge
A. Carefully lift fan assembly onto mounting
bracket. Rotate fan so that the notch on
the ball engages the ridge in the
mounting bracket. This will allow hands-
5
free wiring. For wiring instructions please
refer to page 4 step #7.
Canadian Safety Tips
Page 3 – Designer Supreme-English CUL
Set
screw
3" lag
screw
safety cable
Lift fan assembly and install the safety cable
directly to the building structure using the 3" lag
screw and plain washer provided. Before
proceeding to the next step make sure that the
cable is properly installed and will support
the fan weight. Make sure the screw
3
washer and safety cable are installed using
the order pictured above.
A
Ball
Notch
plain
washer
Advertisement
