Table of Contents
Advertisement
Care and Cleaning
Caring for the Icemaker
The CLEAN light signal will illuminate yellow when
the electronic control senses that the need for
cleaning is approaching. At this time you need to
nickel-safe ice machine cleaner
purchase
Nu-Calgon, available at most appliance repair shops
or through GE Parts and Accessories. Order part
number WX08X42870. In the U.S.A., call 1-800-626-
2002 or visit Monogram.com. In Canada call 1-800-
561-3344. The CLEAN light will eventually turn
red which means the icemaker must be cleaned,
otherwise ice production will decrease signifi cantly
or stop altogether.
IMPORTANT: For best results, use the entire contents
of the bottle to clean the unit. (See
The air-cooled condenser needs to be cleaned
regularly for effi cient ice production and energy
conservation.(See
Cleaning the Condenser
Exterior surfaces
Door handles and trim―Clean with a cloth
dampened with soapy water. Dry with a soft cloth.
Keep the outside clean. Wipe with a clean cloth
lightly dampened with mild liquid dish detergent.
Dry with a clean, soft cloth. Do not wipe the
icemaker with a soiled dish cloth or wet towel. These
may leave a residue that can damage the fi nish.
Do not use scouring pads, powdered cleaners,
bleach or cleaners containing bleach because these
products can scratch and damage the fi nish.
Stainless steel―Regularly clean and polish the
stainless steel door panels and handles (on some
models) with a commercially available stainless
steel cleaner such as Stainless Steel Magic™
to preserve and protect the fi ne fi nish. Stainless
Steel Magic is available through GE Parts and
Accessories, 800.626.2002, or monogram.com.
Order part number WX10X15. Do not use appliance
wax or polish on the stainless steel.
Icemaker System
Note: To remove stubborn buildup, pour a small
amount of cleaning solution on a non-scratching,
blue Scotch-Brite™ pad. Using only front-to-back
motions, clean the top of the plate, the sidewalls,
and the front edge of the evaporator. The front-
to-back motion is important to avoid scratches
that could keep the ice slab from sliding off the
evaporator plate.
1.
2.
by
3.
.)
Icemaker System
4.
.)
5.
6.
7.
8.
– 13 –
Press and hold the
OFF button for 3 seconds.
Wait 5 to 10 minutes for the ice to fall into the
storage bin. Remove all ice from the storage bin.
Unscrew the drain cap from the bottom of the
water reservoir located inside the storage bin as
shown. Allow the water to drain completely.
Drain cap
Replace the drain cap.
For best results, use the entire 16 oz. bottle of
nickel-safe ice machine cleaner
safety precautions on the bottle. Pour one bottle
of solution into the water reservoir. Fill the bottle
twice with tap water and pour it into the water
reservoir.
Press and hold the CLEAN button for 3 sec. The
CLEAN light will begin to blink, indicating that
the cleaning cycle is in process. The cleaning
time is approximately 70 min.
When the indicator light becomes solid and
remains lit, the cleaning cycle is complete.
During the cleaning cycle, the system will both
clean and rinse itself.
After the cleaning cycle is complete, remove
the drain cap from the water reservoir to see
if any cleaning solution, green in color, is left in
the water reservoir. If cleaning solution drains
from the water reservoir, you should run the
clean cycle again adding only tap water to
the reservoir. Be sure to replace the drain cap
before running the cycle again. If the cap is not
securely tightened, water can leak, causing thin
ice or no ice.
Water reservoir
. Follow all
(Continued next page)
Hide quick links:
Advertisement
Table of Contents
